Home > ENGINE > ENGINE COMPONENTS > Pulleys >

5VZ 2.2" SuperGrip Supercharger Pulley
5VZ 2.2" Supercharger Pulley


 
Racer Net: $129.95

Part Number: 1016186
Qty:

Features
 
Features
5VZ 2.2" SuperGrip Supercharger Pulley

There are three different size pulleys. For a daily driven truck we recommend the 2.2" pulley. This is the best overall size that will give you approximately 1.5-2 PSI more boost than the stock 2.37" size pulley and is safe for long term use when properly fueled and tuned. This should only be used with the highest octane fuel available in your area.

Part number
1016187 5VZ Supercharger Pulley is 2.1" normally will give approximately 1-1.5 PSI more boost over the 2.2" pulley. This should be used with 93 octane fuel minimum or used for vehicles at high elevations.

The SuperGrip Supercharger pulleys for the 5VZ TRD Supercharger use an advanced design to enhance performance, reduce belt slippage and extend supercharger belt life.

The SuperGrip Supercharger pulleys are smaller than stock and increase the impeller speed and boost pressure to the engine. When this is combined with the proper fuel upgrades and tuning you will have increased performance.

The TRD Supercharger for the 5vz uses a small 4 rib drive belt. Transfering the torque needed to drive the supercharger from a 4 rib becomes more difficult when the pulley size is reduced. To address this problem the SuperGrip design is used.

The SuperGrip design has three advanced features to enhance belt traction.

  • Tall outer ears
  • Modified rib profile
  • Slit and hole design

The tall out ears grab the outside edges of the belt and make the 4 rib belt act like a 5 rib belt for greater traction and torque transfer.

The modified rib profile improves the contact pattern between the ribs and the belt for greater traction and torque transfer.

The slits and vent holes in pulley gives the air that can get trapped between the belt and pulley a way to escape to the bet stays nice and tight against the pulley and eliminates a "hydroplaning" effect. This gives the best possible traction and torque transfer.

These features result in the most advanced supercharger pulley design available and really makes the pulley look awesome!!

All the SuperGrip pulleys are finishing in a hard anodizing in bright red.

SuperGrip pulleys for the 5vz TRD Supercharger require proper fueling and tuning. We have proven fuel and tuning solutions available. Please review the fuel upgrade kits we offer for your vehicle. Part number

Note- The TRD Supercharger for the 5VZ-FE 3.4L engine uses a slip fit type pulley that is held on with a shaft nut. It does not require the use of the Press Fit Pulley Tool.

5vz Idler Pulley for TRD Supercharger Dynamic Tensioner

1063079 5VZ 7th Injector Upgrade Kit


Check out www.LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters! Or try our new web site LCEPerformance

Note: Images are for illustration purposes only. Images MAY NOT represent the product listed. Please contact Customer Service with any questions or concerns: 928-505-2501.

Average Customer Review: 5 of 5 Total Reviews: 1 Write a review.

  0 of 1 people found the following review helpful:
 
Pulley December 1, 2016
Reviewer: Robert West from Salado, TX United States  
Awesome

Was this review helpful to you?


Browse for more products in the same category as this item:

ENGINE > ENGINE COMPONENTS > Pulleys
BOOST > SUPERCHARGERS > Supercharger Accessories