Mass Airflow Conversion Kit - 22RE (Stage 1)
Any 22RE owner is familiar with the big bulky flap-door air meter that came from the factory on these cars and trucks. For years, there has been little you could do for performance with these meters. Well those days are over! There is now a conversion to eliminate the stock air meter and replace it with the late-model Tacoma mass air meter! These mass air meters are much less restrictive than the stock flap-door air meter that relies on restriction and airflow to move the door in order to meter the air. A hot wire mass airflow sensor uses an exposed wire that cools when more air flows over it. The computer measures the amount in which that wire cools, and adjusts the amount of fuel accordingly. So not only does it flow more air than the trap-door meter, it's also much more accurate! In addition to the MAF conversion, this kit also includes a piggy-back box and software so you can finally tune your factory computer! This kit uses Split Second software to allow you to make fuel and timing adjustments to your computer to compensate for engine modifications. We are offering three separate kits to suit your needs perfectly.
The Stage 1 kit is designed for stock vehicles, and includes the mass airflow sensor, Split Second hardware, a K&N filter, a programming cable to connect to your laptop computer for tuning purposes, and all other wiring accessories like split loom and shrink tubing. This kit comes with programs on disk in the box. Dyno tests showed a gain of 12 horsepower and an incredible 23 lb-ft of torque at the rear wheels! This is on a bone stock 2WD toyota truck with only this conversion!
THIS IS NOT C.A.R.B. APPROVED.
Contact our Tech Support Line for further information at 928-855-6341.
Check out www.LCEngineering.com
for New Products, Tech Articles,
Specials & Monthly Newsletters!