Rear IFS Width Axle Housing Kit IFS Width

(E-Locker W/O Inspection Hole)

Trail-Gear introduces a new concept to the axle housing design. This exclusive design features axle tubes that have been offset above the housing centerline. The inner axles ride near the bottom of the axle tubes rather than in the center. The results are an increase of 3/8" ground clearance under the axle tubing. The heavy-duty, press formed, 1/4" plate steel center section shell is specially shaped to ensure a minimum of 3/4" additional clearance under the differential.

Features:

• Axle tubes are made from 5/16" thick DOM tubing
• 3/4" Additional clearance under differential
• Differential stud kit and RTV silicone are included
• Includes drain plug
• Housings are precision alignment checked using start-of-the-art, 3D digital imaging equipment.
• 4130 Chromoly Outer Offset flanges (to prevent distortion or bending)
• 1/2" plate steel (to ensure studs can not pull out, even under heavy loads)
• 360° gusset welded around the tubes on the inside of the housing (to ensure unparalleled strength)

Specifications:

• Empty housing is 54 lbs
• Overall housing length is 51 3/8" mounting flange to mounting flange.

NOTE: The Rock-Assault axle housings use stock or aftermarket 1986-1995 Toyota Pickup/4Runner axle shafts. Spring perches, shock mounts, and vent not included. An optional fill / inspection cap can be installed for an additional fee. Unpainted bare-metal, oiled finish to prevent rusting. We recommend degrease housing inside & out before installation and painting.

Contact our Tech Support Line for further information at 928-855-6341.

Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!