-
Differential Stud Eliminator Kit When you come home after a trail ride, do you see oil leaking from the center of your axle housings? The stock axle housing studs may be pulling loose. No longer do you have to tap and drill the studs out and replace...$66.06 -
27 Spline Transfer Case Triple Drilled Flange (w/ Dust Cover) Has all the common 1984-1995 patterns in one, universal output flange. Includes 4cyl CV and Non CV patterns as well as V6 CV pattern. Makes sourcing and reversing drive lines much easier...$66.06 -
27 Spline Transfer Case Triple Drilled Flange (w/ Dust Shield) Has all the common 1984-1995 patterns in one, universal output flange. Includes 4cyl CV and Non CV patterns as well as V6 CV pattern. Makes sourcing and reversing drive lines much easier...$66.06 -
Clutch Throw Out Bearing The classic symptom of a worn throw-out bearing is a whirring, growling, or chirping sound when applying the clutch pedal, which goes away after releasing the pedal. Premature wear of the throw-out bearing can occur when there...$64.85 -
27 Spline Drive Shaft Triple Drilled Flange (w/o Dust Cover) Has all the common 1984-1995 patterns in one, universal output flange. Includes 4cyl CV and Non CV patterns as well as V6 CV pattern. Makes sourcing and reversing drive lines much easier...$64.14 -
Driveline Spacer 1.5" (Longfield) Is your driveline too short after you do a lift? We have 1 inch and 1.5-inch spacers with bolts. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...$62.54 -
Driveline Spacer 1" (Longfield) Is your driveline too short after you do a lift? We have 1 inch and 1.5-inch spacers with bolts. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...$62.54 -
Matsuba Drive Shaft U-Joints (Stock Replacement) OEM Replacement U-Joint. We have tested these joints to 3700 ft-lbs of torque before failure. Includes four install clips and Zerk grease fitting. NOTE: Does not fit CV side of driveline. Contact...$60.58 -
Spindle Stud Kit When assembling your spindles gaskets does it feel like your all thumbs? This kit contains (16) studs and flanged nuts. With studs installed it's easier to install the spindle gaskets. Gaskets are placed on the studs one at a time,...$57.96 -
Clutch Master Cylinder The clutch master cylinder is located on the firewall inside the engine bay, usually next to the brake master cylinder. The clutch master cylinder is responsible for transferring the clutch pedal pressure hydraulically to the...$54.30 -
Inspection Plug Installation Kit Extra large differential fill and inspection cap. Designed to allow quick access for inspecting the ring gear. Features1.5" diameter access hole. Threaded aluminum cap uses a rubber o-ring for a tight seal...$53.55 -
Stick Shift Boot (Twin T-case) This boot is designed to work with our Creepy Twin T-Case shifter (above). It features a flexible rubber shell with a steel bottom plate for mounting to your floor board. Great for keeping engine heat and smell out of the...$52.38
-
fast shipping
Speed Delivery