Differential Breather Kit

Prevents dirt, debris and water from getting in to your axle through the stock axle housing breather. Expands and contracts to accommodate increase or decrease in housing pressure. Kit includes one housing fitting, clamp and bellows (as shown). Easy installation takes just a few minutes. No hoses to route. Fits all Toyota Pickup or 4Runner solid axle housings (front or rear).

Note: This product is not compatible with the Trail-Gear rear axle 4 link upper link mount kit.

Contact our Tech Support Line for further information at 928-855-6341.

Check out www.LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!

Note: Images are for illustration purposes only. Images MAY NOT represent the product listed. Please contact Customer Service with any questions or concerns: 928-505-2501.

Average Customer Review:

4 of 5 Total Reviews: 1 Write a review.

0 of 0 people found the following review helpful:

All good	September 11, 2018
Reviewer: Clinton Copeland from Huachuca City , AZ United States

Thanks again guys where's the sticker at though

Was this review helpful to you?

Browse for more products in the same category as this item:

AXLE > GEARS & LOCKERS > Gear Install Kits & Accesories
AXLE > AXLES & ACCESSORIES