This EGR block plate kit contains all plates needed to eliminate the EGR systems on 20R and 22R carbureted engines. This kit will include the three bolt plate that bolts on the cylinder head behind the intake manifold and the two bolt plate that bolts to the intake manifold. Bolts and washers are also included in this kit. The cylinder head plate uses the intake manifold gasket, and the intake plate gasket only comes in gasket kits. If you do not have these gaskets, we recommend using a thin layer of Ultra Grey silicone sealant.
If you're running an aftermarket carburetor on your 20R or 22R engine and you wish to retain the PCV system, you'll need a new place to run your rear PCV hose since the stock connection is part of the stock carburetor base plate. This kit in conjunction with our EGR Block Plate Kit that installs just past the intake manifold will allow you to run your PCV system.
NOTE: For EFI applications, see Part #: 1016039.
* Picture above references applications not requiring PCV relocation.
Contact our Tech Support Line for further information at 928-855-6341.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!