Emissions / Water Block Off Plate Kit - 22R (Carbureted
Sometimes a non-properly working emissions control system can rob power and
cause running problems to your 22R engine. There is no need to replace it when
your vehicle is for off-road use only. So LCE decided to design and fabricate a
kit that comes with all the components and hardware needed to get rid of that
emissions control system once and for all. This kit also contains the block
plates needed to block off the water lines from the back of the timing cover,
as well as the center of the head, and under the intake manifold for those of
you that are going to block off the heater core and / or some of the water
lines on your engine.
Water Block Plate Kit
Intake Block Plate Kit
Block Plate Kit (On Cylinder Head)
Crossover Block Plate Kit
Injection Block Plate Kit
Block Plate Kit (On Carbureted Manifold)
Manifold Plug Kit
Bolts And Gaskets Needed For Installation
How to desmog your 22R Tech Note HERE
*This water plate will fit on any 22R carbureted manifold with the 11-bolt design underneath it. This plate works with stock manifolds or aftermarket designs. You will need to verify the bolt count on the bottom of your manifold since there is an 8 bolt design and an 11 bolt design. The block plate has a 3/8" npt hole in the plate to accommodate a heater or other accessory. This kit comes with a billet aluminum water plate, gasket, mounting hardware, 3/8" npt plug and 90 degree fitting with a 5/8" hose barb.
NOT FOR USE IN ANY POLLUTION CONTROLLED AREAS. WE RECOMMEND IT FOR OFF-ROAD USE ONLY.
NOT FOR EFI APPLICATIONS.
Contact our Tech Support Line for further information at 928-855-6341.
www.LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
Note: Images are for illustration purposes only. Images MAY NOT represent the product listed. Please contact Customer Service with any questions or concerns: 928-505-2501.