Intake Manifold Stud Kit
This kit comes with all new studs to mount your EFI manifold to your cylinder head. This kit also comes with a new long allen bolt to replace to old bolt that goes through the thermostat housing to the head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without having to worry about damaging the threads in your cylinder head. It will all make it easier to install the manifold since you can install the studs first and let the manifold rest on the studs while you install the nuts. This is a lot easier than holding the manifold while trying to install a bolt at the same time!!
NOTE: Studs should be bottomed out in the head, nuts as well as the one long bolt will torque to 14ft lbs.
This product should not be used in a manner that violates Federal EPA Laws.
Contact our Tech Support Line for further information at 928-855-6341.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.