LCE Rear Leaf Spring Set For 1984-1988 4WD Pickup/Hilux (Stock Height)
LCE Rear Leaf Spring Set For 1984-1988 4WD Pickup/Hilux (Stock Height)
 
Our Price: $455.95
Shipping Delay: A 10-12 Week lead time is expected on this item.

Part Number: 4030005
Qty:

Details Fitment
 

LC Engineering Rear Leaf Spring Set

(Stock Height)

For quite some time, LC Engineering has been offering an extra-flex extended leaf spring for Toyota Pick-up and 4Runner’s. Quite a few of our customers are not in need of such an aggressive suspension modification and are looking to replace the factory worn out leaf packs with something new that bolts directly into the factory mounts. We talked to one of the highest quality, suspension component manufacturers on the market and had them make leaf spring sets specifically for us.

When considering a replacement suspension component, it is highly recommended that the quality of parts used are equal to or better than the original factory components. The factory leaf springs on the early Toyota Pick-up and 4Runner’s were fairly stout, but since, have likely fatigued. These replacement leaf springs are of a quality superior to the factory springs to get your vehicle's handling back to where you need it. Look no further! LC Engineering now has the leaf springs you need!

NOTE: These Leaf Spring Sets will take anywhere between 3-4 weeks to ship due to the fact that every Spring Set is custom built for every application.


This product should not be used in a manner that violates Federal EPA Laws.


Contact our Tech Support Line for further information at 928-855-6341.

Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!

Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.


Average Customer Review: Average Customer Review: 5 of 5 5 of 5 Total Reviews: 1 Write a review.

  4 of 5 people found the following review helpful:
 
5 of 5 GREAT SPRINGS FOR 2WD-INSTALLED ON MY 1985 ! January 22, 2016
Reviewer: cpchri1 from WA United States  
I replaced my rear springs on a stock ride and kept my same shock mounts. You must replace the U-Bolts or you will damage the new springs. These springs are about 1/2" thicker in stack height than original springs a new OEM U-bolt may be too short.  The U-bolt that will work perfectly on a 2WD Toyota PU is 1/2" thread, center width of 2-3/4", length of 6" and round.  Alcan Springs can make these U-Bolts for you (they manufacturer these spring for LCE) or a Skyjacker 12X234X6 U-Bolt will work.  Make sure to use new nuts and hardened washers if the nuts are not shouldered.  Also new Prothane motion red urethane bushing come on these springs ends but you'll need the set for the shackles bushing.  For the 2WD is Prothane Motion Control  kit  is part number 18-1002.   Anyway great springs, good install, they make the truck frame flat now (my rear was slightly higher which might explain the thicker stack height vs the original spring).  Follow torque instructions that come with springs too!

Was this review helpful to you?