Oxygen Sensor Block Plate Kit
(2-Bolt Style)
Use where an O2 sensor would mount in the exhaust. Perfect for if you are eliminating the O2 sensor for either stand-alone or carbureted applications where an O2 sensor is not needed.
NOTE: Bolt hole spacing is 1.75" // Studs are M8 x 1.25mm Thread Pitch // 30mm Length.
This product should not be used in a manner that violates Federal EPA Laws.
Contact our Tech Support Line for further information at 928-855-6341.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.
|