Steering Knuckle Pull Scale
A pull scale is helpful in setting up the shims on a knuckle. By increasing the shims above and below the knuckle the knuckle becomes tighter. When installing new knuckle bearings we recommend checking the shims with a pull scale. Attach the pull scale on the steering arm with the tie rod / drag link removed and the felt on the back side of the knuckle not yet installed.
NOTE: The knuckle should not move until about 15 lbs of force is applied to the steering arm.
This product should not be used in a manner that violates Federal EPA Laws.
Contact our Tech Support Line for further information at 928-855-6341.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.