Home > DRIVETRAIN > CLUTCH KITS > CLUTCH COMPONENTS & ACCESSORIES > REPAIR SLEEVE KITS >

Transmission Repair Sleeve Kit - FJ Cruiser 2007-2011 4.0L V6 1GR
Transmission Repair Sleeve Kit - FJ Cruiser 2007-2011 4.0L V6 1GR


 
Our Price: $225.00

Part Number: 1033091
Qty:

Details
 

Transmission Repair Sleeve Kit - FJ Cruiser 2007-2011 4.0L V6 1GR

This Kit replaces Toyota P/N: 31230-60240

DOES YOUR PEDAL FEEL ROUGH OR NOTCHY?

DOES YOUR PEDAL FEEL LIKE IT’S STICKING?

ARE YOU HAVING TO REPLACE YOUR CLUTCH & / OR RELEASE

BEARING MORE OFTEN THAN YOU SHOULD?

THE PROBLEM:

These are the most common symptoms associated with a damaged or grooved quill on a transmission. It is also referred to as the snout, bearing carrier, or case extension. In most cases it is an integral part of the transmission case & cannot be replaced. The logical solution is to replace the case or the transmission. Both options are expensive & time consuming, neither of which solves the problem permanently.

THE CAUSE:

In the operation of the clutch, the release or throw-out bearing slides on the clutch snout or quill, allowing you to engage and disc-engage the clutch mechanism. Due to various reasons the quill becomes grooved over time. If the quill were made of a harder metal than aluminum, this would not be as common. The most common causes are: improper clutch adjustment, defective clutch assemblies, stop & go traffic, keeping your foot on the clutch (commonly referred to as riding the clutch), loss of lubricant, heat, & etc.

THE EFFECT:

The effects of these grooves on the clutch operation are catastrophic. They cause: premature clutch disc wear, premature bearing failure (further adding to the problem), sticky &/or jerky pedal travel, rattling clutch forks, transmission damage, etc.

THE SOLUTION:

The Transmission Sleeve Kit (TSK) solves this problem by utilizing a sleeve, precision machined of 304 Stainless steel, which slips over the original quill. This provides a smooth, hard surface for the oversize bearing to slide on. It is anchored with set screws and is removable & re-usable. As in the case of the Subaru, it must be removed in order to allow any transmission repairs.

THE RESULTS:

After installing the Transmission Sleeve Kit (TSK) you have eliminated the problem forever! You will notice a smooth, fluid like, feel to the pedal. Your engagements will be smoother. Your clutch will last longer. This in turn,

THE KIT:

The kit comes complete with a 304 Stainless steel sleeve, set screws & hex wrench, oversized release bearing, hi-temp grease packet, notification sticker, & instructions. The kit comes with a 1 year, unlimited mileage, warranty.

**FOR MANUAL TRANSMISSIONS ONLY**

Contact our Tech Support Line for further information at 928-855-6341.

Check out www.LCEngineering.com for New Products, Tech Articles,
Specials & Monthly Newsletters!

Note: Images are for illustration purposes only. Images MAY NOT represent the product listed. Please contact Customer Service with any questions or concerns: 928-505-2501.

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

DRIVETRAIN > CLUTCH KITS > CLUTCH COMPONENTS & ACCESSORIES > REPAIR SLEEVE KITS