URD SRunner Tacoma Traction Bar
The URD Traction Bar for the Tacoma SRunner is a special order item
only. When you place your order we will put it into the build cycle and
you should recieve it 4-5 weeks later.
This traction bar also fits 1995-2004 V6 Tacoma 2x4 access cab trucks except Pre-Runner.
The URD traction bar prevents the rear axle housing from twisting in
the leaf springs. This prevents the rear tires from hopping off the
ground when the wheels begin to spin, and provides much better and more
consistent traction for high-power starts and burnouts. This is very
important for quicker hole-shots and reduced reaction times.
The URD traction bar also prevents the rear axle housing from
twisting in the leaf springs during hard braking. And it provides
greater control when accelerating around a turn.
Our traction bar is a unique design that is completely bolt-on. It
consists of a very stout LASER cut and welded bracket that bolts to the
An adjustable torque control bar mounts to the bracket using
high-quality, greaseable polyurethane bushings, travels forward along
the propeller shaft, and mounts to the frame cross member that supports
the propeller shaft carrier bearing using a specially molded
polyurethane bushing. There is an adjustment on the rear of the torque
bar that will allow the user to adjust the preload on the springs to
provide the optimum hole-shot traction.
This model fits the Tacoma SRunner only and will not fit other model Tacomas. Other models fit other applications.
The URD bar comes painted black. You may choose to have it
powdercoated RED at an additional cost. Powdercoating will slightly
Installation note: The muffler used on the stock SRunner is larger
than on most of the two-wheel drive Tacoma trucks. You may need to
modify, move or replace the stock muffler to provide sufficient
clearance for the torque bar. Most aftermarket performance mufflers
provide sufficient clearance.
www.LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
Or try our new web site