Welded Rock Sliders
These heavy duty Rock Sliders are fully welded and ready to bolt on to your new Cruiser using the factory mounting holes. Sliders are made from 1 3/4" X .120" wall 1035 DOM tubing. Sliders are 58" in length. Includes 4 legs on each slider with super beefy gussets on each leg. Mounting hardware is included.
NOTE: Sliders are shipped raw and slightly oiled to prevent rusting.
This product should not be used in a manner that violates Federal EPA Laws.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
| Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501. |
by Trail-Gear
- 2007-2011 FJ Cruiser
To open a printable PDF version of this instruction CLICK HERE
Installation:
-
1. Using jack stands, place sliders at desired position on vehicle. Center bars front to rear between wheel openings. Tilt bars up approximately 15 degrees but make sure that both doors will open without hitting the bars.
2. Cut legs to fit between frame and bars. Cut front leg tube on each side at an angle to match frame. Center and rear legs can all be cut straight.
3. If mounting bars up close to body, maintain 1/4" gap between body and bars to prevent vibrations. Mark body pinch weld with marker for cutting as necessary.
4. Tack weld notched end of legs to sliders. Remove sliders and fully weld legs to bars.
5. Cut half moon shaped sections from pinch weld to clear legs.
6. Place fully welded bars onto stands. Weld bars directly to frame. Make sure to maintain 1/4" gap between body and bars.
7. Cover lower body with cardboard. Clean bars with degreasing fluid. Paint and primer as desired.
Pinch Weld Cutout
Installed
