Odds and Ends

Toyota Ultimate Rear Wheel Bearing Kit This is the first Rear Wheel Bearing Kit that includes the highest-quality components available today without breaking the bank. To ensure quality and...

Dana 60 (29-Spline) to Toyota Triple-Drill Conversion Flange The ultimate solution for Dana 60 axle swaps is here. The conversion flange is specifically designed for off-roaders who want to mate a...

LCE Dual-Axle Differential Breather Relocation Kit Protect your drivetrain from water contamination and premature seal failure with the LCE Differential Breather Kit. In any 4WD vehicle, drivetrain...

Toyota Ultimate Rear Wheel Bearing Kit This is the first Rear Wheel Bearing Kit that includes the highest-quality components available today without breaking the bank. To ensure quality and...

Flexplate Bolt Kit (OEM) Connect that flexplate with confidence. These OEM flexplate bolts are just what the doctor ordered to connect your flexplate to your engine. They have a black oxide finish...

OEM Clutch Fork Boot Keep your clutch components clean with this OEM Clutch Fork Boot. After you find these boots cracked or missing on older trucks, especially on off-road applications. OEM...

Toyota OEM Release Fork Support Genuine Toyota OEM Release Fork Support, part number 31236-30060. This factory replacement component supports the clutch release fork and provides the proper contact...

OEM Shifter Boot (Manual Transmission) It's common for the factory shift lever boot to degrade over time, crumble and disintegrate. This often results in dirt and mud getting into the transmission...

OE Wheel Bearing Grease Seal (Front Hub) Fits in the back side of the front IFS hubs, will be needed anytime you repack or replace front wheel bearings. You will need two seals in order to do your...

Flexplate Bolt (OEM) Connect that flexplate with confidence. This OEM flexplate bolt is just what the doctor ordered to replace your flexplate bolt that you lost or misplaced. They have a black...

Nylon Shift Lever Bushing (End of the Handle) If your shifter on your manual transmission is loose and sloppy, this bushing is in need of replacement. This is an OEM nylon cup that fits over the...

Hub Outer Dial O-Ring (Aisin Manual Hubs) There is a small rubber O-ring located between the inner and outer hub dials. If this ring becomes damaged water and dust can leak into the hubs. It can...