IFS Steering Box
(Remanufactured)
High quality remanufactured IFS boxes for your crossover steering. We carry both newer and older styles. For crossover steering on (1979-1985) trucks we recommend the early style box, but you can also use the late style if you wish. Late style box fits (1989-1995) Pickup and (1990-1995) 4Runners. All boxes are completely rebuilt with new seals and bearings and each unit is tested for quality and performance before shipping.
NOTE: If you're installing crossover steering, you're going to need to mount an IFS steering box, see Part #: 2060013. Frame mount kit includes both inner and outer frame reinforcement plates, grade 8 bolts, DOM tubing, and crimp nuts. With a heavy duty design and angled leading and trailing edges it helps prevent frame cracking. Inner plate is 1/4", outer plate is 3/16".
This product should not be used in a manner that violates Federal EPA Laws.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
| Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501. |
- 1989-1995 Pickup (4x4)
- 1989-1995 4Runner (4x4)
Before Bleeding - Check and Correct as Needed:
- Inspect steering system
- Hoses must not touch any other part of the vehicle
- Steering system noise could be caused by hose touching frame, body or engine
- All hose connections must be tight
- Loose connections might not leak but could allow air into the system
How To Bleed:
-
1. Switch ignition off.
2. Raise front wheels off the ground and secure vehicle with jack stands.
3. Turn steering wheel full left.
4. Fill fluid reservoir to "FULL COLD" level, leave cap off.
5. Turn steering wheel lock-to-lock at least 20 times. On systems with long lines or ram assist cycle steering at least 40 times.
6. Trapped air may cause fluid to overflow - keep fluid level at "FULL COLD".
7. Start engine and maintain fluid level at "FULL COLD".
8. Reinstall Fluid Cap.
9. Keep Engine Running for 2 minutes.
10. Return wheels to center and lower wheels to ground.
11. Turn wheel with engine running.
Verify the Following:
- Smooth power assist
- Noiseless operation
- Proper fluid level
- No system leaks
- Proper fluid condition (no bubbles, foam or discoloration)
