Intake Manifold Plug Kit (Carbureted) This plug kit comes with all the necessary plugs for stock or Offenhauser intake manifolds. The picture shows an Offenhauser manifold with the plug locations. This picture accounts for the most common plug...

Cannon Downdraft Intake Manifold (Weber Flange / Single Plane) One of the most important keys to building a performance engine is to have components that all match up and are designed to work together well. You can put the largest cam and carburetor on...

Sidedraft Manifold w/Linkage (40mm & 45mm Carbs) The LC Engineering 20R Sidedraft Intake Manifold Kit comes complete with Cannon intake manifold, linkage, hardware, gaskets and O-rings. This kit is for use with two Weber DCOE series carburetors as...

Offenhauser Downdraft Intake Manifold (Weber Flange / Single Plane) One of the most important keys to building a performance engine is to have components that match up and are designed to work together in harmony. If you have an awesome cam and...

Sidedraft Manifold w/ Linkage (40mm / 45mm Carbs) This LC Engineering 22R Sidedraft Intake Manifold Kit is for use with two Weber DCOE series carburetors as well as the Mikuni line of sidedraft carburetors. Kit Contents: Cannon intake...

Intake Manifold Stud Kit (Carbureted) This kit comes with all new studs to mount your carbureted manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without...

Intake Manifold Stud Kit This kit comes with all new studs to mount your EFI manifold to your cylinder head. This kit also comes with a new long allen bolt to replace to old bolt that goes through the thermostat housing to the head. Replacing your...

EFI Intake Bolt (Long) M8-1.25 x 95mm Socket Head Cap Screw for use on EFI intake. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

Sidedraft Manifold w/ Linkage (48mm & Larger Carbs) If you are running 48mm or larger sidedrafts then this is the manifold you need. The two-piece design allows the carburetors to be spread apart from each other so you don't get any linkage...

Intake Manifold Stud Kit This kit comes with all new studs to mount your manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without having to worry about...