Electric Fan Kit
Do you own an early model (75-83) Celica or Pickup? Tired of being told that there is no direct fit electric fan kit for it? Well LC Engineering decided to do something about it. Introducing the Universal Electric Fan Kit. This kit comes with custom brackets, electric fan and adjustable temperature sensor. Upgrades are available for a manual on/off switch and A/C relay kit.
Electric Fan:
The kit includes a 10 blade 14" electric fan that pushes 1585cfm! that's more than enough for just about any application!
Bracket Kit:
This universal bracket kit will allow you to mount the fan to the stock shroud location (or any other mounting point you want to use). This will keep the fan off your radiator and eliminate the need to run a thru radiator type strap mount. Kit comes with bolts, nuts and four metal mounting straps.
Adjustable Thermostat:
Turns fan on/off at the desired temperature. Dial-adjustable 180-240 degrees. Gives the freedom to set one temperature for occasional high-demand use, then reset for highway or day-to-day driving.
OPTIONAL A/C/ Relay:
Taps into A/C hot lead. Automatically engages the fan when the air conditioner is turned on, gives your system a head start on the added cooling demand
OPTIONAL Illuminated Fan Switch:
For cockpit control or override of fan function. May be wired to actuate fan regardless of temp setting, or -wired alternately - can be made to disable fan function, regardless of temp setting (for water crossings, etc.)
| Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501. |
- 1975-1980 20R 2.2L Pickup
- 1975-1980 20R 2.2L Celica
- 1981-1983 22R 2.4L Pickup
- 1981-1983 22R 2.4L Celica
- 1983 22RE 2.4L Pickup
- 1983 22RE 2.4L Celica
Installation Instructions:
- Attach the temp. control unit to the mounting bracket using the hardware provided, then push the knob onto the control shaft.
- The control can be mounted to any flat surface in the engine compartment that is within 18" of the radiator inlet hose. Use the 3 mounting screws provided.
- Insert the temp. sensor thru the radiator core as close to the inlet hose as possible, then push the rubber insulator cap over the end of the sensor as shown.
- Connect the "C" terminal on the control unit to the positive (+) lead on electric fan unit. For automatic operation, connect the "2" terminal on the control unit to a fused positive (+) source that is capable of powering the electric fan unit (refer to wiring diagram below). Use the female connectors provided.
- If manual control is desired, use P/N 31148 / 31148N. Refer to wiring diagram below.
NOTE: If not using a Flex-a-lite manual switch, DO NOT connect the ground (-) wire to the switch.
To Adjust Temperature Control:
- Turn the adjusting knob on the controller completely clockwise. Idle the vehicle.
- When the engine temperature gets above normal, turn the adjusting knob counterclockwise until fan activates. Adjusting knob may be adjusted counter-clockwise to reduce the temperature at which fan a activates.
4 Reviews Hide Reviews Show Reviews
-
Jason give 5 stars
-
83 Toyota truck
The electric fan works great, easy to install, great product, thanks
-
Works great
The fit was good and works great!
-
fan kit
Great product with fast shipping!