-
Front CV Axle Outer Boot (Front) Replacement front axle shaft outer boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will...$16.29 -
Outer Tie Rod We all know that if one of your suspension-steering components is not working properly, it will eventually affect your tire alignment or it will make it impossible to align your vehicle. LC Engineering offers only the best replacements...$16.21 -
Water Block Plate (Timing Cover Passenger Side) This block plate goes on the passenger side of the timing cover. Perfect for eliminating the unnecessary water hoses going around your engine compartment. Contact our Tech Support Line for...$16.17 -
Water Block Plate (Under EFI Manifold) This water block off plate goes under the intake manifold on fuel-injected 22RE engines. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...$16.17 -
Water Block Plate (Center Of Head) If you are installing an Offenhauser intake (or if you are eliminating the heater core), there won't be room for the heater core outlet off the cylinder head. This water block plate goes in the center of the cylinder...$16.17 -
Water Block Plate (Timing Cover Driver Side) This block plate goes on the driver's side back of the timing cover which is for deleting the factory heater return line on most 22's. Contact our Tech Support Line for further information at...$16.17 -
Wheel Bearing Nut Kit (Front Hub) Normally the nuts that hold the wheel bearings can be reused over and over again. If your wheel bearing retainer nuts need replacing this kit is for you. Kit Includes: (2) Nuts (1) Star Washer (1) Flat Index...$16.03 -
90 Degree Elbow JIC Need some basic parts for your hydraulic ram steering? With hydraulic hose, high quality crimped connections and JIC 6 ends, these steering components will last. Optional Parts: 1/4" NPT Plug, see Part #: 2060078 Hydraulic...$16.03 -
Intake Manifold Stud Kit (Carbureted) This kit comes with all new studs to mount your carbureted manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without...$16.02 -
OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...$16.01 -
OEM "J" Bolt (Battery Hold Down) OEM Toyota "J" bolt for battery hold down bracket. OEM Toyota Part #: 74451-89103 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...$15.94 -
Flange Dust Shield Dust shield for use with our triple drilled flange, see Part #: 2053174. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...$15.94
-
fast shipping
Speed Delivery