-
O-Ring (Oil Pump) The oil pump O-ring seals and mates the surfaces to keep oil in its respective place. Over time O-rings become brittle and break. Replace a leaky or corroded O-rings before severe damage occurs. OEM Toyota Part #:...$9.26 -
Nylon Shift Lever Bushing (End of the Handle) If your shifter on your manual transmission is loose and sloppy, this bushing is in need of replacement. This is an OEM nylon cup that fits over the ball end of the shift lever (transmission side). We...$9.00 -
Fuel Injector Top Grommets This is a new set of fuel injector grommets that go on the top of the fuel injector. Stop pesky fuel leaks at the fuel rail by replacing these grommets. NOTE: Sold as a set of (4). Contact our Tech Support Line for...$8.52 -
Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...$8.52 -
3mm Allen Wrench (Ball Head) This 3mm allen wrench is used mainly for our TPS screw upgrade kit. The ball end of the wrench allows off angle access to the TPS screws. This makes adjusting the TPS a lot easier if you are doing it in the vehicle. NOTE:...$8.19 -
Crank Trigger Magnet Individual replacement crank position sensor magnets for our Pro Fuel Injection kits. These magnets get installed in the balancer pulley and trigger the hall effect sensor to generate a signal for the ignition system. NOTE: Sold...$8.19 -
Teflon Heat Isolation Gasket (Throttle Body) Teflon Heat Isolator Kits keep the power-robbing heat away from the intake air. This is the ultimate for improving mileage and performance for the price. Installs between the throttle body and intake...$8.19 -
Teflon Heat Isolation Gasket (Throttle Body) Teflon Heat Isolator Kits keep the power-robbing heat away from the intake air. This is the ultimate for improving mileage and performance for the price. Installs between the throttle body and intake...$8.19 -
Plastigage Clearance Indicator (.001-.003 / .025mm-.076mm) Made from a special extruded plastic thread with accurately controlled crush properties, Plastigage provides a fast and accurate way to check bearing clearances. Plastigage is packaged in a...$7.55 -
Throttle Body Gasket (Metal "D" Shape) Throttle body gaskets can be a source of hard-to-find vacuum leaks if the throttle body is removed or disrupted. Any time you remove your throttle body, you should replace the gasket while you're at it. This is...$7.45 -
Air Temp Plate (Adapts Cold Start Injector to Air Temp Sensor) Custom made plate to install an air temperature sensor where the cold start injector normally sits. Contact our Tech Support Line for further information at 928-575-2174...$7.45 -
Johnny Joint Jam Nut (Right Threaded) These jam nuts are good to have if you spend a lot of time working on your rock crawler suspension. These jam nuts tighten against the rod ends to keep them from loosening. 1 1/4"-12 right hand thread jam nut for...$7.17
-
fast shipping
Speed Delivery