T3 Turbo Discharge Gasket (5 Bolt) Stainless Steel T3/T4 Discharge Gasket. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed...

1/4" 90 Degree Fitting (Push-Lok to -4AN Swivel) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This 90 degree fitting is used for the oil feed line at the turbo or block. Perfect for...

2" Silicone Coupler Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following temperature range:...

T3 Turbo Inlet Gasket LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This stainless steel gasket has a crush ring to provide a perfect seal even if there are slight imperfections in...

45° Oil Drain Fitting (1/2" NPT Male to -8AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

T-Bolt Hose Clamp (You Choose Size) Our T-Bolt clamps are all 100% Stainless Steel to stand up to all weather conditions to protect against corrosion. Each clamp has rounded smooth band edges to prevent cutting into you silicone hoses. Engineered and...

1/4" Blue High Pressure Hose (Fuel or Oil / Teflon Lined / Push-Lok Compatible) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This 1/4" hose is perfect as an oil feed for your...

Straight Fitting (1/8" NPT to -4AN) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil feed at the block or turbo. Perfect for going from a 1/8" NPT hole...

Oil Drain Gasket LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This gasket goes between the turbo and the oil drain plate. Contact our Tech Support Line for further information...