-
Pilot Bearing The crankshaft pilot bearing does not require routine maintenance, but should be replaced when clutch replacement becomes necessary. In some cases, pilot bearings can wear excessively when mounting bolts loosen. Contact our Tech...$6.46 -
Tie Rod Boots (Pair) At last it is possible to replace a damaged tie rod dust boot without having the expense of buying an entire new tie rod! These boots resist damage from rocks, sand, water, road salt, and oils better than many other O.E.M. rubber...$6.38 -
Heater Tube O-Ring (Under EFI Manifold) The O-ring seals the heater tube under the EFI intake manifold. Over time O-rings become brittle and break. Replace a leaky or corroded O-rings before severe damage occurs. This is OEM toyota part and may not...$5.85 -
Turbo Compressor Outlet Gasket (CT20) This is a replacement for the OEM turbo compressor outlet gasket for 22RET engines with the CT20 Turbo. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line...$5.70 -
Hub Outer Dial O-Ring (Aisin Manual Hubs) There is a small rubber O-ring located between the inner and outer hub dials. If this ring becomes damaged water and dust can leak into the hubs. It can also make turning the dial difficult. Easy to install...$5.55 -
Caliper Bolt This bolt is the perfect replacement to bolt your caliper to the spindle. After years of service, these bolts can end up stripped or damaged. This is just one of the many parts we carry for brake hardware. Contact our Tech Support...$5.47 -
Drive Shaft Bolt Replacement drive shaft bolts, nuts and washers. Bolts include factory thread lock adhesive already applied to threads. NOTE: Sold individually. See Part #: 2053170 for drive shaft bolt lock washer and Part #: 2053172 for the drive...$5.47 -
Acorn Style Lug Nut Replacement Acorn Style lug nut (M12 X 1.50 thread pitch). NOTE: Sold individually. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at...$5.47 -
8" Pinion & Transfer Case Flange Nut The flange nuts are recommended to be staked or peened over to lock so they are not considered reusable. This stock replacement nut is used on the 8" pinion in the rear 1979-2002 and most transfer case flanges...$5.47 -
Clutch Alignment Tool Used to align splines of disc to pilot bearing for a clutch install. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent...$5.36 -
Round Collector Exhaust Gasket (2-Bolt x 2 1/2" Flange) If you plan to connect your header to the rest of your exhaust, you will need a collector gasket. OEM gaskets feature a carbon material and stainless steel fire ring for a long life and a positive...$5.36 -
Round Collector Exhaust Gasket (2-Bolt x 2 1/4" Flange) If you plan to connect your header to the rest of your exhaust, you will need a collector gasket. OEM gaskets feature a carbon material and stainless steel fire ring for a long life and a positive...$5.35
-
fast shipping
Speed Delivery