-
Rock Ripper Header Kit Trail-Gear has raised the bar yet again in the Toyota Off Road Industry with the newest addition to its product line, stainless steel, 50 state legal Toyota header. Trail Gears header features 100% polished stainless steel 1/16"...$713.04 -
3mm Allen Wrench (Ball Head) This 3mm allen wrench is used mainly for our TPS screw upgrade kit. The ball end of the wrench allows off angle access to the TPS screws. This makes adjusting the TPS a lot easier if you are doing it in the vehicle. NOTE:...$8.19 -
Front Shock Hoops The Universal Shock Hoop Kit is long enough to accommodate a 14" shock, but not so long that you cannot use a 12" shock. The shock hoops are made out of 1035 DOM and are precision CNC bent to ensure the highest quality product. From...$123.13 -
Hub Outer Dial O-Ring (Aisin Manual Hubs) There is a small rubber O-ring located between the inner and outer hub dials. If this ring becomes damaged water and dust can leak into the hubs. It can also make turning the dial difficult. Easy to install...$5.55 -
OEM Main Bolt (Cam Bolt) This is a brand new OEM Toyota main bolt. Ironically this is the same bolt used to hold the cam gear and distributor drive gear onto the front of the cam. Quantity 10 used for crank main caps.OEM Part #:...$7.77 -
Weld-On Attachment Point (Flat) Weld-On Attachment Points are machined from Billet 1020 cold rolled steel. They come in two different fitments, one is coped on the bottom so that it can be welded on to a 3" axle tube, and this one has a flat bottom...$41.05 -
Weld-On Attachment Point (Coped) Weld-On Attachment Points are machined from Billet 1020 cold rolled steel. They come in two different fitments, one is flat on the bottom so that it can be welded on to a plate, tubing, or any other flat surface, and...$44.56 -
Wastegate Block Off Plate (CNC Turbo Manifold) This block off plate goes under the CNC Turbo manifold (2) Bolt Style. 3/8" thick Ceramic Coated to handle the heat from our CNC turbo manifold. Contact our Tech Support Line for further information...$25.90 -
Garrett T3 Exhaust Discharge Flange (4-Bolt) Use 2.5" OD tubing in the groove or 3" OD tubing outside the groove. 3" OD is tight near the bolt holes but works fine so you're not limited to a 2.5" downpipe. Contact our Tech Support Line for...$24.84 -
OEM Head Bolts If you ever remove your cylinder head, you should always replace the head bolts to prolong the service life of your engine. Cylinder head bolts go through a lot of stress, even in stock engines, and retorquing used bolts can sometimes...$69.58 -
Transfer Case Shifter Boot (OEM) It's common for the factory transfer case boot to degrade over time, crumble and disintegrate. This often results in dirt and mud getting into the transfer case shifter then into the transfer case. This simple Factory...$40.16 -
Economy Street Tune-up Kit A tune up kit that won't break the bank, for your 1980 to1992 20R/22R/RE from LC Engineering. Included are four NGK spark plugs BKR5EYA, Distributor cap (black), and a good quality distributor rotor. Kit Includes: (1)...$32.08
-
fast shipping
Speed Delivery