-
LCE EGR Crossover Gasket LCE gasket for that EGR Crossover plate located on the back side of the cylinder head. NOTE: If you are looking to eliminate that EGR crossover, see Part #: 10320007 20R/22R/RE/RET EGR Crossover Block Plate Kit. Contact our...$9.23 -
Nylon Shift Lever Bushing (End of the Handle) If your shifter on your manual transmission is loose and sloppy, this bushing is in need of replacement. This is an OEM nylon cup that fits over the ball end of the shift lever (transmission side). We...$9.00 -
Heavy Duty Shift Spring (Transfer Case) The stock transfer case shift springs tend to give a sloppy feel to the shifters and can lead to the transfer case shift lever popping out of gear on the trail. We recommend heavy duty shift springs be used with...$8.99 -
Axle C-Clip (Inner) This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are...$8.99 -
Birfield Snap Ring This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech...$8.99 -
1/4" Pipe to #6 JIC If you have an IFS steering box and want to tap your own box, this is the fitting you need to do it. This fitting has a male 1/4" pipe fitting on one end and male #6 JIC fitting on the other. NOTE: (2) fittings are required for...$8.73 -
Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...$8.52 -
Teflon Heat Isolation Gasket (Throttle Body) Teflon Heat Isolator kits keep the power-robbing heat away from the intake air. By keeping the heat out of the intake manifold, the incoming air is cooler, therefore making more power. This is the ultimate...$8.20 -
3mm Allen Wrench (Ball Head) This 3mm allen wrench is used mainly for our TPS screw upgrade kit. The ball end of the wrench allows off angle access to the TPS screws. This makes adjusting the TPS a lot easier if you are doing it in the vehicle. NOTE:...$8.19 -
Crank Trigger Magnet Individual replacement crank position sensor magnets for our Pro Fuel Injection kits. These magnets get installed in the balancer pulley and trigger the hall effect sensor to generate a signal for the ignition system. NOTE: Sold...$8.19 -
OEM Main Bolt (Cam Bolt) This is a brand new OEM Toyota main bolt. Ironically this is the same bolt used to hold the cam gear and distributor drive gear onto the front of the cam. Quantity 10 used for crank main caps.OEM Part #:...$7.77 -
Poly-Vinyl Shock Boots (Black / Pair) These high quality shock boots protect the chrome-hardened piston rod from dirt, dust, mud and other contaminants - extending the life of your shocks. Features: Not Vehicle Specific Poly-Vinyl Shock...$7.56
-
fast shipping
Speed Delivery