Fuel Pump Relay Fuel pump Relay for Pro Fuel Injection Kits. Required for the computer to turn on the electric fuel pump. Much easier than having an additional switch on the dashboard! Contact our Tech Support Line for further information at...

Coolant Temp Sensor This coolant temperature sensor is a replacement for our LC Pro Fuel Injection Kits. This sensor has 3/8" NPT threads with a GM style weather pack connector. Contact our Tech Support Line for further information at...

Hall Sensor Mount This bracket is needed if you are installing our Pro Fuel Injection Systems on a 22RE engine. This mount will locate the Hall sensor in the right location for both the stock pulley and the LC Engineering underdrive pulley. This...

Distributor Plug This plug is designed to plug the hole in the cylinder head after removing the distributor. This is part of the Pro Fuel Injection setup we offer. Contact our Tech Support Line for further information at 928-575-2174...

Serial Cable Serial Cable to connect your computer to split second box or, SDS computer to SDS controller. Length: 10ft / 3m Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...

Crank Trigger Magnet Individual replacement crank position sensor magnets for our Pro Fuel Injection kits. These magnets get installed in the balancer pulley and trigger the hall effect sensor to generate a signal for the ignition system. NOTE: Sold...

Air Temp Plate (Adapts Cold Start Injector to Air Temp Sensor) Custom made plate to install an air temperature sensor where the cold start injector normally sits. Contact our Tech Support Line for further information at 928-575-2174...