-
Resonator (w/o Inlet & Outlet Tubes) These are great to use as a muffler for that "old school" sound, or we have used them as a resonator to quiet down your existing exhaust system. The 18" length is perfect for adding this resonator in conjunction...$42.80 -
Flex Coupler (2 1/2" x 6") To reduce the stress on your exhaust system, we have these flex couplers to weld or clamp onto your pipe. Under acceleration, your engine has a tendency to torque to one side. A flex coupler will allow the engine to torque...$42.80 -
Resonator (w/ Inlet & Outlet Flanges) These are great to use as a muffler for that old school sound, or they can be used in conjunction with the LC Engineering Pro Flow Exhaust system for a quieter tone. This resonator features a high temp long...$117.78 -
Heat Riser Tubing (1.5" x 36") This heat riser tubing is just what you need if you need to keep the choke plate on your carbureted engine hooked to the exhaust for emissions purposes. This tubing goes from the heat shield on the exhaust manifold to the...$37.20 -
Heat Riser Kit (Attaches Heat Riser To Air Cleaner) This kit is used to connect a heat riser tube to the stock air cleaner assembly. This kit can be used on any header with 1.5" primary tubes. Kit Includes: (3) Hose clamps (1) 1.5″ Standoff (1)...$76.43 -
Oxygen Sensor Adapter (2-Bolt Style To Thread In Style) This kit will adapt a thread in style O2 sensor (18mm) to the Toyota two-bolt style. Includes gasket plate to adapt and two studs and nuts. Contact our Tech Support Line for further...$18.16 -
U Bend (6″ Radius) Use these 3" U-Bends for building your own headers or replacing a bent or damaged tube. NOTE: Size listed is the outside diameter. Constructed of mild steel. Contact our Tech Support Line for further information at...$46.85 -
Wastegate Block Off Plate (CNC Turbo Manifold) This block off plate goes under the CNC Turbo manifold (2) Bolt Style. 3/8" thick Ceramic Coated to handle the heat from our CNC turbo manifold. Contact our Tech Support Line for further information...$25.90 -
Garrett T3 Exhaust Discharge Flange (4-Bolt) Use 2.5" OD tubing in the groove or 3" OD tubing outside the groove. 3" OD is tight near the bolt holes but works fine so you're not limited to a 2.5" downpipe. Contact our Tech Support Line for...$24.84 -
Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...$8.52 -
Exhaust Manifold Stud and Nut When installing new aftermarket headers, new hardware should be used. An even clamping force is required to keep the header tight against the head in order to seal the exhaust gasket properly. The studs on your truck may...$4.12 -
Air Injection Tube Block-off Plate Kit (Trail Gear) Trail-Gear has come up with this very clean way to totally eliminate your stock air injection tube. This kit contains 2 plates that will allow you to install our headers without the air injection tube...$27.24
-
fast shipping
Speed Delivery