Model

Fuel Pump Eccentric When eliminating the fuel pump eccentric from the stock distributor, you will need this spacer to bring the drive gear back into alignment. This is an OEM core unit processed by LC Engineering. Only used on 22R when eccentric is...

Coolant Temperature Sensor This coolant temperature sensor is a stock replacement for 22RE/RTE engines. After years of use, a sensor can go bad and give false readings to the ECU, that is why we recommend replacing those sensors that have been sitting...

Street Distributor Cap New OEM style replacement distributor cap. A must when changing spark plug wires. Distributor caps can develop carbon tracks that can wreak havoc on the electrical path inside the distributor cap and cause drivability issues...

Coil Adapter Wire (20" Long) Have you updated the ignition on your 20R/22R/22RE/3VZ but haven't gotten around to replacing the distributor yet? No problem, LC Engineering has that special coil wire to connect a Fast Ignition to Stock Distributor...

Clutch Throw Out Bearing The classic symptom of a worn throw-out bearing is a whirring, growling, or chirping sound when applying the clutch pedal, which goes away after releasing the pedal. Premature wear of the throw-out bearing can occur when there...

Rear Main Seal OEM replacement rear main seal. This will install on the big end of the crankshaft. If there is a large groove on the crank seal surface be sure to get our seal saver for trouble-free installation. For the Seal Saver, see Part #:...

Thermostat (180 Degree) Reduced engine temperatures add life to your engine and provide a denser air/fuel mixture which helps produce more horsepower. Consistent control of the engine temperature allows an engine to operate at its peak efficiency, no...

Exhaust Valve Seat (20+ Lbs of Boost) 33mm Pro Valve Seats are made of Nickel Aluminum Bronze material for extra-long life in performance engines. With track proven results the machine-ability, longevity, and thermal conductivity far surpass the stock...

Shaft Tail Bearing (Rear Pinion) This bearing is for the end of the pinion gear, closest to the splines. The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with...

Street Rod Bushing Set (4) Any time you remove your connecting rods it is a good idea to change out the piston pin bushings. After a while, the bushings will wear out causing the piston to "walk" in the bore and could eventually cause major engine...

O-Ring & Isolator Kit O-Ring and Isolator set for Weber sidedraft carburetors. Kit Contains: (2) Plastic O-ring plates (4) O-Rings (4) Springs NOTE: Each kit will only service (1) carburetor, make sure you order (2). Contact our Tech...

Exhaust Valve (Stainless Steel / 40mm +2mm) These are the same 40mm exhaust valves we use in our stage 5 cylinder heads. 40mm exhaust valves are designed for use in heavily ported high-performance applications only. They must be used with matching...