Flat Pitman Arm This Pitman Arm is a solid forged flat arm, no drop, one piece design, and features a FJ80 tapered hole. Ideal for use with crossover steering and custom applications. NOTE: OEM Solid axle applications only. This product should not...

Stock Drop Pitman Arm This Stock Drop Pitman Arm is a solid one piece, forged design, and features a FJ80 tapered hole. For use with crossover steering and features the same drop as the factory pitman arm. This product should not be used in a manner...

Knuckle Felt Protector Kit (Rock-Ring) We have had a lot of people tell us they don't like the stock inner felt plates because they are so thin and are easily damaged in the rocks. Well check out this trick solution... super heavy duty rings made from...

Solid Axle Knuckle Service Kit (w/o Wheel Bearings) When was the last time you serviced your knuckles? This service kit contains all standard replacement parts including gaskets, felts, seals, washers and shims. Kit includes inner axle seals and outer...

Lower Knuckle Caps (Solid Axle) These stock replacement caps fit on the bottom of 79-85 Toyota solid axle knuckles. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information...

Trail Safe Knuckle Ball Wiper Seal Tired of wiping big clumps of dirty sandy grease off of your knuckle balls after every trip? So are we. We asked our engineering department to look at the problems with the OEM design along with what was currently...

Steering Pump Kit Hoses This kit contains one high pressure and three low pressure power steering lines. These lines are used to connect the pump, steering box and cooler together. The two hoses that go from the steering ram to the steering box are not...

Steering Columns 3 1/4 Inches: This steering column will allow you to use your existing Toyota steering linkage without having to buy a coupler and then cut and weld on your steering shaft. This steering column measures 3 1/4 inches from the base of...

Clevis End Kit Our Clevis End Kit is the most complete and affordable kit on the market. All hardware is included along with the necessary spacers. The Clevis ends are clear zinc-plated for a sharp look and long lasting finish. This kit will fit most...

Ram Mounting Kit (Double Ended) This kit will take almost all the fabrication work out of mounting your Rock Assault Double Ended Ram and Clevis Kit to almost any axle housing. The main support tube is pre-bent and can be trimmed to size and coped on...

Toyota Knuckle Rebuild Kit (w/o Wheel Bearings) Some people prefer knuckle rebuild kits with brand name Japanese "Koyo" trunnion bearings. Other than the brand of the bearings, the only difference in this kit is that the outer felt rings are not...