-
Driveline Spacer 1.5" (Longfield) Is your driveline too short after you do a lift? We have 1 inch and 1.5-inch spacers with bolts. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...$62.54 -
Driveline Spacer 1" (Longfield) Is your driveline too short after you do a lift? We have 1 inch and 1.5-inch spacers with bolts. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...$62.54 -
Matsuba Drive Shaft U-Joints (Stock Replacement) OEM Replacement U-Joint. We have tested these joints to 3700 ft-lbs of torque before failure. Includes four install clips and Zerk grease fitting. NOTE: Does not fit CV side of driveline. Contact...$60.58 -
Clutch Master Cylinder The clutch master cylinder is located on the firewall inside the engine bay, usually next to the brake master cylinder. The clutch master cylinder is responsible for transferring the clutch pedal pressure hydraulically to the...$54.02 -
Inspection Plug Installation Kit Extra large differential fill and inspection cap. Designed to allow quick access for inspecting the ring gear. Features1.5" diameter access hole. Threaded aluminum cap uses a rubber o-ring for a tight seal...$53.55 -
Stick Shift Boot (Twin T-case) This boot is designed to work with our Creepy Twin T-Case shifter (above). It features a flexible rubber shell with a steel bottom plate for mounting to your floor board. Great for keeping engine heat and smell out of the...$52.38 -
OEM Clutch Release Fork Sub-Assembly OEM Toyota Shift Fork For Clutch Release. OEM Toyota Part #: 31204-20071 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only...$44.42 -
Solid Pinion Spacer Solid pinion spacers prevent loosening of the gear setup preload. Originally designed for older Toyota applications, Toyota stopped using them decades ago. Solid spacer and shims replace the crush sleeve. It takes a little longer...$43.00 -
Solid Pinion Spacer (High Pinion) Solid pinion spacers prevent loosening of the gear setup preload. Originally designed for older Toyota applications, Toyota stopped using them decades ago. Solid spacer and shims replace the crush sleeve. It takes a...$43.00 -
Stainless Steel 11" Clutch Line Don't get stuck with a leaking or inoperable clutch hydraulic system! This kit replaces the stock rubber line that extends down to your clutch slave cylinder.When your stock lines get old, the rubber starts to expand...$42.19 -
Transfer Case Shifter Boot (OEM) It's common for the factory transfer case boot to degrade over time, crumble and disintegrate. This often results in dirt and mud getting into the transfer case shifter then into the transfer case. This simple Factory...$40.16 -
OEM Clutch Release Fork Sub-Assembly OEM Toyota OEM Clutch Release Fork Sub-Assembly. OEM Toyota Part #: 31204-35031 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...$37.09
-
fast shipping
Speed Delivery