Axles

Rear Rock Assault Axle Housing Kit (IFS Width) The axle tubes are now made from 5/16" thick, high strength DOM tubing and engage 5/8" farther into the center section. On top of that, there is a 360° gusset welded around the tubes on the inside of...

Chromoly Rear Axle Shaft Set (Longfield) Big tires and low crawler gears can lead to broken rear axles. If you are looking to upgrade your drivetrain, check out our heavy-duty chromoly rear axles. These axles feature a break strength of 8,300 ft-lbs...

LCE OEM IFS Spindle Bushing & Seal Kit Restore the factory-smooth performance of your front end with the LCE OEM IFS Spindle Bushing & Kit. Over decades of use, the original brass bushings in your Toyota's Independent Front Suspension (IFS) wear...

TrakMotive Extended Travel HD CV Axle Eliminate premature axle failure and maximize your rig's front suspension performance with the TrakMotive Extended Travel Heavy-Duty CV Axle. When you install a suspension lift kit or crank up your torsion bars, it...

Front CV Axle Shaft Replacement front axle shaft for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension.Left and right shafts are the same. NOTE: Sold individually. Contact our Tech Support Line for further information at...

LCE Dual-Axle Differential Breather Relocation Kit Protect your drivetrain from water contamination and premature seal failure with the LCE Differential Breather Kit. In any 4WD vehicle, drivetrain assemblies like differentials, transmissions, and...

Inspection Plug Installation Kit Extra large differential fill and inspection cap. Designed to allow quick access for inspecting the ring gear. Features1.5" diameter access hole. Threaded aluminum cap uses a rubber o-ring for a tight seal...

Axle Breather Relocation Kit This Breather Relocation Kit was specifically designed to relocate your rear axle breather when welding up a rear axle gusset or any type of mount or bracket. This kit uses our Creeper Breather to keep any dirt, mud, or...

Axle Housing Breather (Replacement) Factory Toyota axle housing breather. Internal spring loaded flapper valve prevents water from entering through breather during water crossings. Stock replacement for old, rusted or damaged units. This product...

Front CV Axle Outer Boot (Front) Replacement front axle shaft outer boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will...

CV Axle Inner Boot (Front) Replacement front axle shaft inner boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will allow...

Rear Outer Axle Seal (Rubber) Replacing your rear axle seals will cure annoying gear oil leaks from your rear housing, and keeps oil off your rear brakes. You should replace the rear seal any time you remove the axle. Contact our Tech Support...