ARP Heavy Duty Steering Knuckle Stud Magnum knuckle studs are stronger than any other stock replacement Toyota knuckle stud on the market. These heavy-duty studs are manufactured by world-renowned bolt manufacturer ARP (Automotive Race Products). Each...

Power Steering Pump Belt (Rock Assault) Replacement belt for Rock Assault power steering kits. Don't get caught out on the trail without a spare! This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support...

Steering Box Mount /Reinforcement (IFS Steering Box) If you're installing crossover steering on your 79-85 4wd Toyota you're going to need to mount an IFS steering box. Angled leading and trailing edges prevent frame cracking. Heavy duty design with a...

1/4" Pipe to #6 JIC If you have an IFS steering box and want to tap your own box, this is the fitting you need to do it. This fitting has a male 1/4" pipe fitting on one end and male #6 JIC fitting on the other. NOTE: (2) fittings are required for...

90 Degree Elbow JIC Need some basic parts for your hydraulic ram steering? With hydraulic hose, high quality crimped connections and JIC 6 ends, these steering components will last. Optional Parts: 1/4" NPT Plug, see Part #: 2060078 Hydraulic...

Power Steering Pump Bracket Kit (Rock Assault) This pump bracket is designed to adapt our "TC" style power steering pumps to your 75-95 Toyota 20R/22R/RE/RET engine. This bracket will utilize the stock idler pulley for the power steering belt. NOTE:...

Shim Pack (Six Shooter Knuckle) Shim pack for 6-shooter knuckles. In order to maintain proper steering geometry and prevent binding or mis-alignment, we offer this assortment of shims. Contact our Tech Support Line for further information at...

by Trail-Gear

Rock Assault Steering Stops A good set of steering stops is critical so that your steering does not over travel and damage other steering or axle components. Our Rock Assault steering stops are machined from solid billet so you will never have to worry...

Hydro Assist Bracket (OEM Axle Housing / Rock Assault Axle Housing / Tie Rod) Our mounting brackets have a 3/4" or 5/8" bolt hole. The Hydro Assist Brackets are designed to fit a OEM Toyota solid axle front housing, Rock Assault Axle Housings and 1.25"...

Sector Shaft Nut and Washers Replacement nut and washer for bolting on pitman arm to steering box. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...

Steering Box Fitting (High Pressure) This special fitting is used to connect the high pressure steering hose to the steering box. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further...