Trail Gear Brake Line Clip & Mount (Rear Line Only) This brake line mount kit is designed to fit Trail Gear extended length brake lines. If you've added a little (or a lot) extra ground clearance and suspension travel, you probably have added some...

Caliper Bleeder Screw The caliper bleeder screws are often stripped out and difficult to open. Replace your damaged, clogged, or stripped out caliper bleeder screw with one of these. This is just one of the many parts we carry for brake hardware...

Bleeder Cap (Rubber) When you replace the bleeder screw, be sure to replace this rubber cap. This cap keeps dirt and other debris from finding its way into the hole in the bleeder. Clogged bleeder screws can be a pain when it comes to bleeding your...

Caliper Bolt Washer This washer is used with our replacement caliper bolts. Replace the washers when you replace the bolts. This is just one of the many parts we carry for brake hardware. Contact our Tech Support Line for further information at...

Swagelok (1/8" NP Male To 3/16" Tubing) These neat little devices make it much easier to plumb in brake accessories, like proportioning valves, line locks etc... One end has 1/8"npt threads to go into most brake accessory ports. The opposite end has a...

Wilwood Proportioning Valve (Adjustable) This light and tidy, knob-type proportioning valves can be installed almost anywhere in the brake lines. They allow you to tweak brake bias in big or little increments simply by twisting the large adjuster knob...

Line Lock (Mechanical) This mechanical line lock will allow you to use your normal brake hydraulics to hold your brakes locked. You plumb your rear brake line through this line lock and then you simply press the line lock button down while pushing your...

Residual Valve (2 PSI) When converting your rear drum brakes to disc you will need to hold pressure on the rear line to keep the pads in contact with the rotors. If you don't then you will have to pump your pedal to get a firm brake feel. This residual...