Rear Inner Axle Seal Replacing your rear axle seals will cure annoying gear oil leaks from your rear housing, and keeps oil off your rear brakes. You should replace the rear seal any time you remove the axle. Contact our Tech Support Line for...

Aisin Manual Locking Hub Factory new Toyota locking hub. Fits solid axle Toyota Pickups and 4Runners from 1979-1985. This is the strongest unit for the Toyota Solid Axle, they will last four times longer than other manual hubs. NOTE: Sold as a pair...

Axle C-Clip (Inner) This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are...

Round Hub Gasket (Front Hub) This OEM Toyota gasket comes in handy when rebuilding or replacing your hubs. It goes at the base of the locking hub assembly. If you plan on working on your front end have one ready to go as they seem to always rip. OEM...

Front Hub Star Gasket These gaskets come in extremely handy when rebuilding your front hubs. These star-shaped gaskets are used for the front cover of the 4wd hub assembly. OEM Toyota Part #: 43531-60010 Contact our Tech Support Line for...

Dana 60 Drive Flange Kit Tired of breaking your manual locking hubs on the trail? Well we have a great solution to that problem, our new Dana 60 Drive Flange Kit (35 spline). This kit will replace your existing 35 spline internal locking hubs or your...

Longfield Chromoly Hub Gears Set (Inner and Outer / IFS) When you run bigger tires, you put more strain and wear on your axles and hubs creating more failure points. Keep your rig running problem-free with Longfield OEM replacement hub gears made...

Oil Pan Kit (3RZ Tacoma w/ Solid Axle Swap) When installing a solid axle swap kit on your 95-04 Tacoma, you will notice that your stock oil pan will interfere with the new solid axle. We have solved this problem with a Rear Sump T100 oil pan kit. This...

Oil Pan Kit 3.4L V6 (5VZ-FE Tacoma w/Solid Axle Swap) When installing a solid axle swap kit on your 95-04 Tacoma, you will notice that your stock oil pan will interfere with the new solid axle. We have solved this problem with a T100 oil pan kit. This...

Hub Outer Dial O-Ring (Aisin Manual Hubs) There is a small rubber O-ring located between the inner and outer hub dials. If this ring becomes damaged water and dust can leak into the hubs. It can also make turning the dial difficult. Easy to install...

Wheel Bearing & Seal Kit (Front) LC Engineering understands the importance of having all the parts needed for the job. With that being said we made a kit, so when you change the wheel bearings, you have all the necessary gaskets and seals as well...

8" Pinion & Transfer Case Flange Nut The flange nuts are recommended to be staked or peened over to lock so they are not considered reusable. This stock replacement nut is used on the 8" pinion in the rear 1979-2002 and most transfer case flanges...