27 Spline Transfer Case Triple Drilled Flange (w/ Dust Shield) Has all the common 1984-1995 patterns in one, universal output flange. Includes 4cyl CV and Non CV patterns as well as V6 CV pattern. Makes sourcing and reversing drive lines much easier...

27 Spline Drive Shaft Triple Drilled Flange (w/o Dust Cover) Has all the common 1984-1995 patterns in one, universal output flange. Includes 4cyl CV and Non CV patterns as well as V6 CV pattern. Makes sourcing and reversing drive lines much easier...

26" Extended Brake Line (Front / Female - Female) These steel braided brake lines are 26" long and are DOT approved. Front lines use factory mounting clips so there is no need to modify the factory clips in any way. Specifications: Size:...

26" Extended Brake Line (Rear / Female - Male) These steel braided brake lines are 26" long and are DOT approved. Front lines use factory mounting clips so there is no need to modify the factory clips in any way. Specifications: Size...

Koyo Front Wheel Bearing Kit (Made in Japan) We are constantly asked whether we have Koyo Front bearings for the 79-85 4wd Toyota Pickups and 4Runners. Well, we listened. LC Engineering now stocks Japanese Koyo Front Wheel bearing kits. Kit...

Spindle Stud Kit When assembling your spindles gaskets does it feel like your all thumbs? This kit contains (16) studs and flanged nuts. With studs installed it's easier to install the spindle gaskets. Gaskets are placed on the studs one at a time,...

Rock Assault Steering Stops A good set of steering stops is critical so that your steering does not over travel and damage other steering or axle components. Our Rock Assault steering stops are machined from solid billet so you will never have to worry...

Inner Brass Bushing (Front Axle Replacement) This replacement brass axle bushing is recommended any time you're replacing your axles. Bushing centers front axle in housing. NOTE: (2) are required per axle, one on each side. This is only for front...

Inspection Plug Installation Kit Extra large differential fill and inspection cap. Designed to allow quick access for inspecting the ring gear. Features1.5" diameter access hole. Threaded aluminum cap uses a rubber o-ring for a tight seal...

Upper Gusset (Solid Front Axle) This gusset welds on top of your Toyota front solid axle and helps prevent bending of the axle housing. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for...

Toyota Backing Plate Eliminator (w/ Brake Line Holder) Toyota solid axle backing plates (sometimes called dust shields) seem to become damaged with even the slightest touch, but removing them leaves your brake hard lines unsecured. On the other hand,...

Solid Pinion Spacer (High Pinion) Solid pinion spacers prevent loosening of the gear setup preload. Originally designed for older Toyota applications, Toyota stopped using them decades ago. Solid spacer and shims replace the crush sleeve. It takes a...