AXLE

Manual Hub Conversion Kit This kit is a must when converting from Toyota Automatic Hubs to Manual Hubs. This kit includes special locking nuts and plates that are necessary to lock the wheel hub and rotor onto the spindle when converting to manual hubs...

Brake Hard Line Kit (Left & Right) This caliper hard line kit is for straight axle Trucks and 4Runners only. This kit includes the caliper brake lines for both the right and left sides. NOTE: Not for IFS vehicles. Contact our Tech Support...

Pinion Head Bearing The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with some replacement parts for these Celica rear ends. This is the bearing that rides on the...

Carrier Bearing (Pinion Side) Carrier bearing for the 6.7" Celica differential. The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with some replacement parts for...

Shaft Tail Bearing (Rear Pinion) This bearing is for the end of the pinion gear, closest to the splines. The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with...

Trail Safe Pinion Seal Tired of dealing with oil leaks from your pinion gear? Trail-Gear has remedied that issue by offering our new Trail-Safe™ Pinion Seal. The Trail Safe™ Pinion seal lip is totally supported by a garter spring applying constant...

Trail Safe 29-Spline Pinion Seal Tired of dealing with oil leaks from your pinion gear? Trail-Gear has remedied that issue by offering our new Trail-Safe™ Pinion Seal. The Trail Safe™ Pinion seal lip is totally supported by a garter spring applying...

Crush Collar Replacement crush collar for the 6.7" Celica differential. The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with some replacement parts for these...

Axle Housing Breather (Replacement) Factory Toyota axle housing breather. Internal spring loaded flapper valve prevents water from entering through breather during water crossings. Stock replacement for old, rusted or damaged units. This product...

Front CV Axle Outer Boot (Front) Replacement front axle shaft outer boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will...

Wheel Bearing Nut Kit (Front Hub) Normally the nuts that hold the wheel bearings can be reused over and over again. If your wheel bearing retainer nuts need replacing this kit is for you. Kit Includes: (2) Nuts (1) Star Washer (1) Flat Index...

Flange Dust Shield Dust shield for use with our triple drilled flange, see Part #: 2053174. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...