Axle Housing Breather (Replacement) Factory Toyota axle housing breather. Internal spring loaded flapper valve prevents water from entering through breather during water crossings. Stock replacement for old, rusted or damaged units. This product...

Front CV Axle Outer Boot (Front) Replacement front axle shaft outer boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will...

Wheel Bearing Nut Kit (Front Hub) Normally the nuts that hold the wheel bearings can be reused over and over again. If your wheel bearing retainer nuts need replacing this kit is for you. Kit Includes: (2) Nuts (1) Star Washer (1) Flat Index...

Flange Dust Shield Dust shield for use with our triple drilled flange, see Part #: 2053174. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...

CV Axle Inner Boot (Front) Replacement front axle shaft inner boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will allow...

Rear Outer Axle Seal (Rubber) Replacing your rear axle seals will cure annoying gear oil leaks from your rear housing, and keeps oil off your rear brakes. You should replace the rear seal any time you remove the axle. Contact our Tech Support...

Shim Kit Shim kit for setting up gears in 6.7" Celica differentials to get the correct gear mesh pattern. The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with...

Hub Stud Kit Don’t need an entire hub stud kit? Well here you go, in the single version. Kit Contains: (1) Stud (1) Cone washer (1) Lock washer (1) Nut (8mm) Contact our Tech Support Line for further information at 928-575-2174...

Rear Inner Axle Seal Replacing your rear axle seals will cure annoying gear oil leaks from your rear housing, and keeps oil off your rear brakes. You should replace the rear seal any time you remove the axle. Contact our Tech Support Line for...

OE Wheel Bearing Grease Seal (Front Hub) Fits in the back side of the front IFS hubs, will be needed anytime you repack or replace front wheel bearings. You will need two seals in order to do your truck. NOTE: Not for Solid Axle applications. For...

Rear Pinion Seal The pinion seal will need to be replaced any time the gear ratios are changed. This pinion seal is a high quality oil seal that will offer you years of service. The 6.7" Toyota differential is becoming increasingly more difficult to...

Inner Axle Seal When you swap out a Birfield joint it's a good idea to change the inner axle seal at the same time to keep the knuckles clean of weeping oil. This is a great part to keep in your tool box for trail side repairs. This product should...