AXLE

Inner Axle Seal When you swap out a Birfield joint it's a good idea to change the inner axle seal at the same time to keep the knuckles clean of weeping oil. This is a great part to keep in your tool box for trail side repairs. This product should...

Hub Stud Kit Don’t need an entire hub stud kit? Well here you go, in the single version. Kit Contains: (1) Stud (1) Cone washer (1) Lock washer (1) Nut (8mm) Contact our Tech Support Line for further information at 928-575-2174...

Pumpkin Gasket New gasket to seal the pumpkin to the housing on the 6.7" Celica differential. The 6.7" Toyota differential is becoming increasingly more difficult to find parts for. Fortunately, LC Engineering has come to the rescue with some...

Axle C-Clip (Inner) This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are...

Birfield Snap Ring This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech...

Hub Outer Dial O-Ring (Aisin Manual Hubs) There is a small rubber O-ring located between the inner and outer hub dials. If this ring becomes damaged water and dust can leak into the hubs. It can also make turning the dial difficult. Easy to install...

Drive Shaft Bolt Flange Nut Replacement drive shaft bolts, nuts and washers. Bolts include factory thread lock adhesive already applied to threads. NOTE: Sold individually. See Part #: 2053168 for drive shaft bolt and Part #: 2053170 for the...

OEM Knuckle Stud Factory Toyota knuckle hardware. Don't let knuckle stud failure ruin your day, get the best. NOTE: Sold Individually.       Contact our Tech Support Line for further information at 928-575-2174.   Note: Images are...

OE Knuckle Cone Washer Factory Toyota knuckle hardware. Don't let knuckle stud failure ruin your day, get the best. NOTE: Sold Individually. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for...

Rear Axle Wheel Stud These wheel studs are for rear axle application and has M12 X 1.50 threads. NOTE: Solid axle only. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further...

Drive Shaft Bolt Replacement drive shaft bolts, nuts and washers. Bolts include factory thread lock adhesive already applied to threads. NOTE: Sold individually. See Part #: 2053170 for drive shaft bolt lock washer and Part #: 2053172 for the drive...

8" Pinion & Transfer Case Flange Nut The flange nuts are recommended to be staked or peened over to lock so they are not considered reusable. This stock replacement nut is used on the 8" pinion in the rear 1979-2002 and most transfer case flanges...