Brass Freeze Plug At the beginning of any complete engine build-up, the block needs to be cleaned. To do that, all of the block's plugs must be removed (even with a new engine) to allow cleaning access to areas that enable oil or coolant to flow. LC...

Allen Head Hardware Kit (Oil Pump Cover) On your 2RZ/3RZ engine, replacing the hardware is recommended every time you remove your oil pump cover, Phillip's screws get worn out, and the heads are easily stripped if you don't use an impact screwdriver...

Silicone Vacuum Hose (3mm / 6mm / 8mm / 10mm ) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the...

Water Block Plate (Timing Cover Passenger Side) This block plate goes on the passenger side of the timing cover. Perfect for eliminating the unnecessary water hoses going around your engine compartment. Contact our Tech Support Line for...

Water Block Plate (Under EFI Manifold) This water block off plate goes under the intake manifold on fuel-injected 22RE engines. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...

Water Block Plate (Center Of Head) If you are installing an Offenhauser intake (or if you are eliminating the heater core), there won't be room for the heater core outlet off the cylinder head. This water block plate goes in the center of the cylinder...

Water Block Plate (Timing Cover Driver Side) This block plate goes on the driver's side back of the timing cover which is for deleting the factory heater return line on most 22's. Contact our Tech Support Line for further information at...

PCV Relocation Kit If you're running an aftermarket carburetor on your 20R or 22R engine and you wish to retain the PCV system, you'll need a new place to run your rear PCV hose since the stock connection is part of the stock carburetor base plate...

Oil Filter Housing Seal Kit (OEM) When removing the oil filter housing, it is always a good idea to replace these two O-ring seals. Any leak in this area can contaminate the system and affect oil pressure, not to mention the mess in the engine...

OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley without alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley with alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...