High Capacity Oil Pan
(w/ Solid Axle Swap)
This is the oil pan you must have if you are putting that solid front axle in your Tacoma or early model Toyota truck. The pan features anti-rust coating, custom pickup tube, windage tray, and trap doors to keep the oil by the pickup. This pan even comes with the drain plug and washer. For all 3RZ motors.
NOTE: These oil pans are built when ordered and average a 4 week lead time to produce.
| Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501. |
- 1995.5-2004 2RZ 2.4L Engines (w/ Solid Axle Swap)
- 1995.5-2004 3RZ 2.7L Engines (w/ Solid Axle Swap)
To open a printable PDF version of this instruction CLICK HERE
LC Engineering's oil pans give you the extra protection from oil starvation by building "doors" around the oil pick-up to keep the pick up screen in oil at all times. Always test fit the pan before final installation. Since these pans are made for so many different years, there may be some minor modifications needed. Check for proper oil pick up tube and dipstick clearance. You may have to trim the windage screen to gain extra clearance. Always be sure to clean the pan and pick up completely prior to final installation!
Installation:
- Place new pan on bench and fill with fluid to 1/4" below baffle, make sure you write down the amount of fluid you used.
- Install pan and fill with the same amount of oil as above. Then mark oil dipstick showing full.
- Start engine and let it run for about 2-3 minutes, this will allow the lines, oil filter, etc. to get filled.
- Shut off and wait between 2-3 minutes and re-check level, top-off if necessary.
