INTAKE

Throttle Position Sensor Plug (w/ Wires) As time marches on Toyota will, little by little, discontinue parts it carries for the 22R/22RE powered trucks. We are here working hard to step in and make sure that the parts you need are still out there to...

Throttle Position Sensor Plug (w/ Wires) As time marches on Toyota will, little by little, discontinue parts it carries for the 22R/22RE powered trucks. We are here working hard to step in and make sure that the parts you need are still out there to...

PreCharger Wrap (8.8" Cone) Add an additional layer of filtration and extend the life of your air filter with Trail-Gear’s new Rock Ripper™ Dust Defense Pre-Filter. The TG Rock Ripper™ Dust Defense Pre-Filter is made from high-quality polyester...

PreCharger Wrap Add an additional layer of filtration and extend the life of your air filter with Trail-Gear’s new Rock Ripper™ Dust Defense Pre-Filter. The TG Rock Ripper™ Dust Defense Pre-Filter is made from high-quality polyester with an...

Silicone Adapter (2.5“ I.D. to 2.75″ I.D.) Building your own custom air intake or cooling system? Trail-Gear is proud to offer the same silicone adapters and couplers that we use on our own Extreme Air Intake line. We have the most popular...

Silicone Adapter (2.5 “ I.D. to 3.0″ I.D.) Building your own custom air intake or cooling system? Trail-Gear is proud to offer the same silicone adapters and couplers that we use on our own Extreme Air Intake line. We have the most popular...

Carb Linkage Kit This kit contains the vital components needed for converting to a Weber 32/36 or 38 carburetor. Comes with linkage brackets, fuel feed nipples, hoses, and clamps. Contact our Tech Support Line for further information at...

S&B Stock Replacement (66-2050) With the high cost of a decent stock style paper filter, why not consider a higher flowing cleanable cotton filter? S&B's filters are made with silicone in all the places the competition uses Urethane rubber. The...

Weber Cable Linkage Kit This throttle cable linkage kit allows you to connect your throttle cable to your Weber DGV, DGAV, DGEV, and DGMS carbs. It comes with a return spring and bracket. If you have picked up a Weber that is setup for mechanical...

Distributor Plug This plug is designed to plug the hole in the cylinder head after removing the distributor. NOTE: This is a part for the Pro Fuel Injection (SDS) setup we offer, not factory set-ups. Contact our Tech Support Line for further...

Intake Manifold Plug Kit (Carbureted) This plug kit comes with all the necessary plugs for stock or Offenhauser intake manifolds. The picture shows an Offenhauser manifold with the plug locations. This picture accounts for the most common plug...

Idle Cut-off Solenoid This solenoid threads into the Electric Choke version of the Weber 32/36 carburetor and closes off the flow of fuel in the idle circuit when the ignition is cut. Contact our Tech Support Line for further information at...