INTAKE

Throttle Body Rebuild Kit Have an old worn out throttle body? Well, you are in luck! We have developed this kit that includes a new throttle body gasket, new shaft seals, and LC Engineering's own idle speed screw so you can rebuild yours. Call and...

-6AN Fuel Rail Fitting (Aftermarket Fuel Regulator) Need to connect your Aftermarket Fuel Pressure Regulator to your fuel rail? LC Engineering offers this fitting that goes right into your own fuel rail on your 22RE/22RET. With this fitting there is no...

Coolant Temperature Sensor (Square Plug) This Temperature Sensor is a stock replacement for 22RE engines. After years of use, electronic components can go bad and give false readings, that is why we recommend replacing them with new ones for accurate...

Fuel Pressure Bolt Kit Ever wonder if the fuel regulator is doing its job? Not sure if you're getting the right fuel pressure at the fuel rail? This new fuel bolt kit is the solution to the problem. This kit will replace the banjo bolt on the cold start...

Temperature Gauge Sender This Temperature Gauge Sender is a stock replacement for 22RE engines. After years of use, electric components can go bad and give false readings, that is why we recommend replacing them with new ones, for accurate readings...

Coolant Temperature Sensor This coolant temperature sensor is a stock replacement for 22RE/RTE engines. After years of use, a sensor can go bad and give false readings to the ECU, that is why we recommend replacing those sensors that have been sitting...

O-Ring & Isolator Kit O-Ring and Isolator set for Weber sidedraft carburetors. Kit Contains: (2) Plastic O-ring plates (4) O-Rings (4) Springs NOTE: Each kit will only service (1) carburetor, make sure you order (2). Contact our Tech...

Intake Manifold Stud Kit This kit comes with all new studs to mount your EFI manifold to your cylinder head. This kit also comes with a new long allen bolt to replace to old bolt that goes through the thermostat housing to the head. Replacing your...

Fuel Injector Caps (Green Cap) These clear injector caps fit 3VZ V6 injectors. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (6). Contact our Tech Support Line for...

Throttle Cable Up-Grade For custom applications such as sidedraft carburetors or race cars with different routing, this throttle cable end will make fabrication of a throttle cable a breeze. Simply cut the stock cable to length, attach this cable end...

Fuel Injector Rebuild Kit LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. Don't forget the cap end which is sold separately, there are two different styles depending on your year so make sure to...

Intake Manifold Stud Kit (Carbureted) This kit comes with all new studs to mount your carbureted manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without...