INTAKE

Coolant Temperature Sensor This coolant temperature sensor is a stock replacement for 22RE/RTE engines. After years of use, a sensor can go bad and give false readings to the ECU, that is why we recommend replacing those sensors that have been sitting...

O-Ring & Isolator Kit O-Ring and Isolator set for Weber sidedraft carburetors. Kit Contains: (2) Plastic O-ring plates (4) O-Rings (4) Springs NOTE: Each kit will only service (1) carburetor, make sure you order (2). Contact our Tech...

PreCharger Wrap (8.8" Cone) Add an additional layer of filtration and extend the life of your air filter with Trail-Gear’s new Rock Ripper™ Dust Defense Pre-Filter. The TG Rock Ripper™ Dust Defense Pre-Filter is made from high-quality polyester...

PreCharger Wrap Add an additional layer of filtration and extend the life of your air filter with Trail-Gear’s new Rock Ripper™ Dust Defense Pre-Filter. The TG Rock Ripper™ Dust Defense Pre-Filter is made from high-quality polyester with an...

Intake Manifold Stud Kit This kit comes with all new studs to mount your EFI manifold to your cylinder head. This kit also comes with a new long allen bolt to replace to old bolt that goes through the thermostat housing to the head. Replacing your...

Manual Choke Kit (w/ Cable) If you are looking to convert your electric choke Weber 32/36 or 38 carbs to a manual choke application, look no further. Kit Includes: Cable Bracket Hardware Contact our Tech Support Line for further information...

Fuel Injector Caps (Green Cap) These clear injector caps fit 3VZ V6 injectors. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (6). Contact our Tech Support Line for...

Throttle Cable Up-Grade For custom applications such as sidedraft carburetors or race cars with different routing, this throttle cable end will make fabrication of a throttle cable a breeze. Simply cut the stock cable to length, attach this cable end...

Fuel Injector Rebuild Kit LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. Don't forget the cap end which is sold separately, there are two different styles depending on your year so make sure to...

Intake Manifold Stud Kit (Carbureted) This kit comes with all new studs to mount your carbureted manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without...

Fuel Injector Cups (w/ O-Rings) Fuel Injector Cups and O Rings for OEM Toyota 22RT-E fuel injectors. Located on the Intake Manifold for the injectors to sit in. Age and heat will take its toll on these plastic parts. They never come out whole and...

Silicone Adapter (2.5“ I.D. to 2.75″ I.D.) Building your own custom air intake or cooling system? Trail-Gear is proud to offer the same silicone adapters and couplers that we use on our own Extreme Air Intake line. We have the most popular...