INTAKE

DCOE Jet Cover (w/ Wing Nut) LC Engineering offers only genuine Weber/Redline products. Don't get fooled by cheap imitations out there, they will never perform as good as genuine Weber equipment. Contact our Tech Support Line for further...

Power Valve This will fit the genuine Weber 32/36 or 38 Carbs we sell. These are not included in the rebuild kits. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only...

-6AN Fuel Rail Fitting (Aftermarket Fuel Regulator) Need to connect your Aftermarket Fuel Pressure Regulator to your fuel rail? LC Engineering offers this fitting that goes right into your own fuel rail on your 22RE/22RET. With this fitting there is no...

Coolant Temperature Sensor (Square Plug) This Temperature Sensor is a stock replacement for 22RE engines. After years of use, electronic components can go bad and give false readings, that is why we recommend replacing them with new ones for accurate...

Fuel Pressure Bolt Kit Ever wonder if the fuel regulator is doing its job? Not sure if you're getting the right fuel pressure at the fuel rail? This new fuel bolt kit is the solution to the problem. This kit will replace the banjo bolt on the cold start...

Temperature Gauge Sender This Temperature Gauge Sender is a stock replacement for 22RE engines. After years of use, electric components can go bad and give false readings, that is why we recommend replacing them with new ones, for accurate readings...

Coolant Temperature Sensor This coolant temperature sensor is a stock replacement for 22RE/RTE engines. After years of use, a sensor can go bad and give false readings to the ECU, that is why we recommend replacing those sensors that have been sitting...

O-Ring & Isolator Kit O-Ring and Isolator set for Weber sidedraft carburetors. Kit Contains: (2) Plastic O-ring plates (4) O-Rings (4) Springs NOTE: Each kit will only service (1) carburetor, make sure you order (2). Contact our Tech...

PreCharger Wrap (8.8" Cone) Add an additional layer of filtration and extend the life of your air filter with Trail-Gear’s new Rock Ripper™ Dust Defense Pre-Filter. The TG Rock Ripper™ Dust Defense Pre-Filter is made from high-quality polyester...

PreCharger Wrap Add an additional layer of filtration and extend the life of your air filter with Trail-Gear’s new Rock Ripper™ Dust Defense Pre-Filter. The TG Rock Ripper™ Dust Defense Pre-Filter is made from high-quality polyester with an...

Intake Manifold Stud Kit This kit comes with all new studs to mount your EFI manifold to your cylinder head. This kit also comes with a new long allen bolt to replace to old bolt that goes through the thermostat housing to the head. Replacing your...

Manual Choke Kit (w/ Cable) If you are looking to convert your electric choke Weber 32/36 or 38 carbs to a manual choke application, look no further. Kit Includes: Cable Bracket Hardware Contact our Tech Support Line for further information...