-6AN Fuel Rail Fitting (Fuel Inlet) LC Engineering offers this fitting that threads into your stock fuel rail inlet on your 22RE/22RET. It comes with an O-ring and a crush washer. NOTE: M14 x 1.50 to -6AN fitting. We also sell replacement Fuel Rails...

Union Bolt (Fuel Rail) LC Engineering offers this M14 x 1.25 replacement Union Bolt that threads into the front of your fuel rail. This also replaces the fuel damper on early 22RE fuel rails. Contact our Tech Support Line for further information...

Temperature Gauge Sender This temperature sender is a stock replacement for 22RE engines. After years of use, electric components can go bad and give false readings to the ECU, that is why we recommend replacing them with new ones, for accurate...

Oil Pressure Light Switch This Oil Pressure Light Switch is a stock replacement for 22RE engines and it is only for vehicles with stock oil pressure light on the dashboard, not for gauge. After years of use, electric components can go bad and give...

Holley Power Valve (3.5″) These power valves are an important component in the power enrichment circuit of Holley's performance carburetors. They operate by using engine vacuum to control their opening and closing rate. When they open, additional fuel...

Holley Power Valve (2.5″) These power valves are an important component in the power enrichment circuit of Holley's performance carburetors. They operate by using engine vacuum to control their opening and closing rate. When they open, additional fuel...

Fuel Injector Caps These black injector caps fit Type C & Turbo model injectors only. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (4). For Type E or F caps, see Part #:...

Fuel Injector Isolators (Bottom) To isolate injectors in the stock intake manifold LC Engineering suggests changing these when rebuilding the engine or when servicing the fuel injectors. LC Engineering flow-matched fuel injectors include new isolators...

Injector Connector So... you've pulled off the connectors to your fuel injectors and managed to break one side of them. Now they won't stay on and that blob of RTV just isn't very pretty or effective. This injector connector is just what you need. It...

Injector Connector So... you've pulled off the connectors to your fuel injectors and managed to break one side of them. Now they won't stay on and that blob of RTV just isn't very pretty or effective. This injector connector is just what you need. It...

Injector Harness Adapter (Denso to Bosch EV1) This injector harness adapter installs between the stock injector plug and a new fuel injector with no cutting or splicing required. This is the cleanest way for you to install an aftermarket fuel injector...

Fuel Injector Caps (Green Cap) Replace those old brittle troublesome caps with a new set through LC Engineering. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (4). For Type C...