Distributor Plug This plug is designed to plug the hole in the cylinder head after removing the distributor. NOTE: This is a part for the Pro Fuel Injection (SDS) setup we offer, not factory set-ups. Contact our Tech Support Line for further...

Throttle Body Rebuild Kit Have an old worn out throttle body? Well, you are in luck! We have developed this kit that includes a new throttle body gasket, new shaft seals, and LC Engineering's own idle speed screw so you can rebuild yours. Call and...

-6AN Fuel Rail Fitting (Aftermarket Fuel Regulator) Need to connect your Aftermarket Fuel Pressure Regulator to your fuel rail? LC Engineering offers this fitting that goes right into your own fuel rail on your 22RE/22RET. With this fitting there is no...

Coolant Temperature Sensor (Square Plug) This Temperature Sensor is a stock replacement for 22RE engines. After years of use, electronic components can go bad and give false readings, that is why we recommend replacing them with new ones for accurate...

Fuel Pressure Bolt Kit Ever wonder if the fuel regulator is doing its job? Not sure if you're getting the right fuel pressure at the fuel rail? This new fuel bolt kit is the solution to the problem. This kit will replace the banjo bolt on the cold start...

Temperature Gauge Sender This Temperature Gauge Sender is a stock replacement for 22RE engines. After years of use, electric components can go bad and give false readings, that is why we recommend replacing them with new ones, for accurate readings...

Coolant Temperature Sensor This coolant temperature sensor is a stock replacement for 22RE/RTE engines. After years of use, a sensor can go bad and give false readings to the ECU, that is why we recommend replacing those sensors that have been sitting...

Fuel Injector Caps (Green Cap) These clear injector caps fit 3VZ V6 injectors. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (6). Contact our Tech Support Line for...

Fuel Injector Rebuild Kit LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. Don't forget the cap end which is sold separately, there are two different styles depending on your year so make sure to...

Fuel Injector Cups (w/ O-Rings) Fuel Injector Cups and O Rings for OEM Toyota 22RT-E fuel injectors. Located on the Intake Manifold for the injectors to sit in. Age and heat will take its toll on these plastic parts. They never come out whole and...

-6AN Fuel Rail Fitting (Fuel Inlet) LC Engineering offers this fitting that threads into your stock fuel rail inlet on your 22RE/22RET. It comes with an O-ring and a crush washer. NOTE: M14 x 1.50 to -6AN fitting. We also sell replacement Fuel Rails...

Union Bolt (Fuel Rail) LC Engineering offers this M14 x 1.25 replacement Union Bolt that threads into the front of your fuel rail. This also replaces the fuel damper on early 22RE fuel rails. Contact our Tech Support Line for further information...