Fuel Injector Caps (Green Cap) Replace those old brittle troublesome caps with a new set through LC Engineering. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (4). For Type C...

Fuel Injector Top Grommets This is a new set of fuel injector grommets that go on the top of the fuel injector. Stop pesky fuel leaks at the fuel rail by replacing these grommets. NOTE: Sold as a set of (4). Contact our Tech Support Line for...

Teflon Heat Isolation Gasket (Throttle Body) Teflon Heat Isolator kits keep the power-robbing heat away from the intake air. By keeping the heat out of the intake manifold, the incoming air is cooler, therefore making more power. This is the ultimate...

Idle Air Compensator Valve O-Ring This is the OEM rubber o ring gasket that is used on the 1989 to 1995 Toyota 22RE throttle bodies for the IAC valve. What is an IAC it is an idle air compensator valve directly associated with the idle control on the...

Air Intake Tube Clamp Need to connect the air intake duct and secure it properly? Simply get these clamps into place, and snug it down. Nothing makes a job easier than having proper fitting replacement parts. Look no further, LC has you covered. OEM...

Idle Air Compensator Valve O-Ring This is the OEM rubber o ring gasket that is used on the 2000-2004 Toyota 3RZ throttle bodies for the IAC valve. What is an IAC it is an idle air compensator valve directly associated with the idle control on the 3RZ...

Idle Air Compensator Valve O Ring This is the OEM rubber o ring gasket that is used on the 1995 to 2000 Toyota 3RZ throttle bodies for the IAC valve. What is an IAC it is an idle air compensator valve directly associated with the idle control on the...

22RE Fuel Pressure Damper Washer This fuel damper washer is a stock replacement for the worn out one. You will need (1) as well as (1) of these 1025050 washers for each damper. NOTE: Sold individually. Contact our Tech Support Line for further...

OEM Vent Hose Spring Clamp Need to connect the vent hose and secure it properly? Simply get these spring clips into place, and release. Nothing makes a job easier than having proper fitting replacement parts. Look no further, LC has you covered. OEM...

Fuel Injector O-Rings Located on the fuel rail end of the injectors. LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. LC Engineering flow-matched fuel injectors include new o-rings in the kit...

OEM Sealing Washer This sealing washer for sensors is an OEM stock replacement for Toyota engines. OEM Toyota Part #: 90430-12005 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...

Crush Washer This Crush Washer is a stock replacement for the worn out ones on the Cold Start Injector on Toyota engines. Sold as each. You will need (2) for each cold start injector. NOTE: Sold individually. Contact our Tech Support Line for...