-
Vacuum Hose Information (Under Hood Decal) If you have had to replace or repaint your hood then you understand the frustrations of not having this around. Get your under hood decals back on and save yourself the frustrations later. NOTE: Only for the...$10.25 -
LC Engineering T-Shirt (Mens Classic) Show your support at the races or while you're out rock crawling with an LC Engineering t-shirt! Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for...$10.00 -
LC Engineering Women's V-Neck T-Shirt (Charcoal / Classic) Show your support at the races or while you're out rock crawling with an LC Engineering t-shirt! Contact our Tech Support Line for further information at 928-575-2174. Note: Images...$10.00 -
Valve Cover Gasket This valve cover gasket features precision edge-molded silicone rubber, which resists high heat and delivers reliable sealing on irregular surfaces. This silicone rubber is wrapped around a rigid carrier that adds strength to the...$9.95 -
Air Temp Plate (Adapts Cold Start Injector to Air Temp Sensor) Custom made plate to install an air temperature sensor where the cold start injector normally sits. Contact our Tech Support Line for further information at 928-575-2174...$9.85 -
Thermostat (160 Degree) There is really only one reason to run this thermostat. Race tracks that require vehicles to run water, no coolant, this is the thermostat you need. We would not recommend this for any vehicle running coolant. See our 180°...$9.27 -
LCE Performance Patch (5.5" Wide x 3" Tall) This is an LCE first! 2023 LCE Performance patch. Customize all your favorite gear from pull-overs to jackets to backpacks and more! Grab up the newest patch in the market right here at LCEPerformance.com...$9.27 -
LCE EGR Crossover Gasket LCE gasket for that EGR Crossover plate located on the back side of the cylinder head. NOTE: If you are looking to eliminate that EGR crossover, see Part #: 10320007 20R/22R/RE/RET EGR Crossover Block Plate Kit. Contact our...$9.23 -
3mm Allen Wrench (Ball Head) This 3mm allen wrench is used mainly for our TPS screw upgrade kit. The ball end of the wrench allows off angle access to the TPS screws. This makes adjusting the TPS a lot easier if you are doing it in the vehicle. NOTE:...$8.19 -
Crank Trigger Magnet Individual replacement crank position sensor magnets for our Pro Fuel Injection kits. These magnets get installed in the balancer pulley and trigger the hall effect sensor to generate a signal for the ignition system. NOTE: Sold...$8.19 -
Idle Air Compensator Valve O-Ring This is the OEM rubber o ring gasket that is used on the 1989 to 1995 Toyota 22RE throttle bodies for the IAC valve. What is an IAC it is an idle air compensator valve directly associated with the idle control on the...$7.86 -
Plastigage Clearance Indicator (.001-.003 / .025mm-.076mm) Made from a special extruded plastic thread with accurately controlled crush properties, Plastigage provides a fast and accurate way to check bearing clearances. Plastigage is packaged in a...$7.55
-
fast shipping
Speed Delivery