4Runner

Outer Tie Rod We all know that if one of your suspension-steering components is not working properly, it will eventually affect your tire alignment or it will make it impossible to align your vehicle. LC Engineering offers only the best replacements...

Exhaust Valve (Stock Length) (Stainless Steel / 37.5mm) In 2019 LC Engineering revised it's Stainless Steel Exhaust Valve and shortened it to match the OEM valve length measurement allowing us to cater to the home builder (rather than being forced to...

Water Block Plate (Under EFI Manifold) This water block off plate goes under the intake manifold on fuel-injected 22RE engines. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...

Blow Off Valve Weld On Fitting (You Choose Material) All our blow-off valves come supplied with aluminum adapters but if you are using a steel intake tube you will need the steel weld-on adapter, Aluminum weld-on adapters are designed to work with...

Turbo Oil Drain Plate (w/ 1/2" NPT Boss For Block Side) Provides a 1/2" NPT port for a custom oil drain fitting. Eliminates the need to use the hard-to-find factory thread fitting that comes from the factory. Contact our Tech Support Line for...

Thrust Bearing Set (Standard) When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end. These bearing sets will get your engine back to the proper specification and ready for the miles to come. The...

Intake Valve (Stock Length) (Stainless Steel / 45.5mm) In 2019 LC Engineering revised it's Stainless Steel Intake Valve and shortened it to match the OEM valve length measurement allowing us to cater to the home builder (rather than being forced to...

Silicone Adapter (2.5" to 3") Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

Intake Manifold Stud Kit (Carbureted) This kit comes with all new studs to mount your carbureted manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without...

Fuel Injector Cups (w/ O-Rings) Fuel Injector Cups and O Rings for OEM Toyota 22RT-E fuel injectors. Located on the Intake Manifold for the injectors to sit in. Age and heat will take its toll on these plastic parts. They never come out whole and...

Oil Filter Housing Seal Kit (OEM) When removing the oil filter housing, it is always a good idea to replace these two O-ring seals. Any leak in this area can contaminate the system and affect oil pressure, not to mention the mess in the engine...

OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...