4Runner

Heavy Duty Shift Spring (Transfer Case) The stock transfer case shift springs tend to give a sloppy feel to the shifters and can lead to the transfer case shift lever popping out of gear on the trail. We recommend heavy duty shift springs be used with...

Axle C-Clip (Inner) This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are...

Birfield Snap Ring This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech...

Exhaust Valve (Steel / Stock Size 36.5mm) If you're looking for replacement valves for your Toyota 22R/RE/RET engine, then these high-strength steel OE type replacement valves are just right for you. These valves utilize the factory size valve seats...

OEM PCV Valve (Steel) A Factory replacement OEM PCV valve with steel design straight up outlet. Use this PCV to replace the stock one that has the molded rubber hose. Don't forget the new PCV grommet, see Part #: 1024084 or the new hose from Toyota...

NGK Spark Plug R5672A-8 (10-18 Psi / 14:1 Comp) LC Engineering carries NGK V-Power spark plugs, which offer economical performance for your Toyota, and are the only plugs with NGK's V-Groove technology. They enhance the spark kernel, lower the voltage...

Spring Seat / Shim (Dual Springs) The LC Engineering 5VZ/1GR Pro Dual Valve Spring Seats are designed to be used with the Pro Dual Valve Springs. NOTE: Sold individually. This product should not be used in a manner that violates Federal EPA Laws...

OEM Main Bolt (Cam Bolt) This is a brand new OEM Toyota main bolt. Ironically this is the same bolt used to hold the cam gear and distributor drive gear onto the front of the cam. Quantity 10 used for crank main caps.OEM Part #:...

Fuel Injector Top Grommets This is a new set of fuel injector grommets that go on the top of the fuel injector. Stop pesky fuel leaks at the fuel rail by replacing these grommets. NOTE: Sold as a set of (4). Contact our Tech Support Line for...

Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...

Idle Air Compensator Valve O-Ring This is the OEM rubber o ring gasket that is used on the 1989 to 1995 Toyota 22RE throttle bodies for the IAC valve. What is an IAC it is an idle air compensator valve directly associated with the idle control on the...

Street Distributor Rotor The distributor rotor rotates inside the distributor and transfers the high tension current from the coil to the towers of the distributor cap. The firing end of the rotor, from which the high tension spark jumps to each of the...