Model

Balance Shaft Bearing Remove & Install Tool This is a custom designed tool (machined from billet aluminum) for removing and installing balance shaft bearings in 3RZ and 2TR engines. Contact our Tech Support Line for further information at...

Timing Cover Hardware (Single Chain Kit) This kit is all the hardware you will need for the installation of the late model Timing Chain Cover in most applications. All hardware is zinc plated, or black oxide coated. NOTE: This kit will not address any...

OEM Flywheel Bolt Kit Connect that flywheel with confidence. These OEM flywheel bolts are just what the doctor ordered to connect your flywheel to your engine. They have a black oxide finish to help resist rust and corrosion. Recommended to be replaced...

Front Axle Torque Arm Bushings Stock rubber bushings are subject to the same deterioration problems as other rubber products. This causes control problems associated with road wander. Gain additional handling by replacing your rubber bushings with...

20R Intake Manifold Plug Kit This plug kit comes with all the necessary plugs for a Cannon Intake Manifold. There are two holes that need this shouldered plug to seal. If you look at the picture you will see that there is a "step" in the hole that the...

Throttle Body Rebuild Kit Have an old worn out throttle body? Well, you are in luck! We have developed this kit that includes a new throttle body gasket, new shaft seals, and LC Engineering's own idle speed screw so you can rebuild yours. Call and...

Power Steering Belt (1981 - 1995) Pickup & 4Runner 22R/RE/RET This high Performance V-Belt is designed with being a workhorse in mind, the polyester cord provides maximum power transfer and tension holding capability for the life of the belt. The...

OEM Coolant Bypass Union (Elbow) This elbow is a genuine OEM Toyota part. This is the 90 degree pipe that screws into the underside of the lower intake manifold that meets the coolant line from the back of the passenger side of the timing cover. It can...

Gasket Set (Timing Chain Cover) High-quality timing cover gasket set for (85-95) 22R and 22RE engines. Does not fit early (75-84) blocks, for those engines, use Part #: 1015045. Contact our Tech Support Line for further information at...

Stock Replacement U-Joint (Heavy Duty w/ Zerk) Looking for a top quality replacement U-Joint? This joint has been tested to 4,000 Ft.-Lbs. of torque in our axle testing machine. These joints are up to any task and will handle high output motors and low...

-6AN Fuel Rail Fitting (Aftermarket Fuel Regulator) Need to connect your Aftermarket Fuel Pressure Regulator to your fuel rail? LC Engineering offers this fitting that goes right into your own fuel rail on your 22RE/22RET. With this fitting there is no...

Clutch Slave Cylinder The clutch slave cylinder is typically located on the side of the transmission. The clutch slave cylinder receives hydraulic pressure from the clutch master cylinder which pushes the slave cylinder shaft out to actuate the clutch...